Other Network Architecture Subjects

Hi, I've got a problem with transfer of long sized (80 - 100 GB) files via FTP between two Unix servers. Two servers are on different sites and LAN connections to local routers (one is 2610 and the other is 3640) are fastethernet. Connection between ...

We are faced with a problem on our Cisco OSR Gateway router. The GE-WAN interfaces on this routers are highly utilized so we have to use 64 bit V2c counters to get the correct in and out counters. Our MRTG config has not changed in a while and we are...

We have a 3745 router with eight 28.8kbps analog modems on POTS lines and six digital modems (56K capable) attached to three ISDN BRI lines. The router functions as a small dial-up access server. It uses Windows 2000 RADIUS (IAS) to validate userna...

I would like to set up policy routing to track my customers IP traffic. This customer will have a T1 line that connects him to my network and he will have equipment co-located on my network. I would like to charge him only for the T1 traffic to the I...

???

Hi, I´d like to know how many servers are supported by IOS SLB 12.1(13)E9 in a Cat. 6506.Thank you.

hi,i want to police my eth0/0 that traffic to 75000b/s is forwarded mit ip prec 5, from 75000 to 256000b/s should be forwarded with ip prec 0 and above 256000 b/s itraffic should be droped.normally i could do this with:class gold_bank police cir 75...

Hi There.I am looking for a way to map a host on the LAN side to a WAN IP directly so that all requests to all ports on this IP address would be routed to it. All that on a Cisco 1750 that runs NAT for the rest of the network.ThanksAmir

We recently installed CiscoWorks 2000 LMS (RME v3.5) and have noticed that devices which have been reloaded are not appearing in the Reloads Report. RME's Availability Polling has been configured to poll all devices for reload information every 2 ho...

I have a point-to-point T1 I am trying to bring up. I cannot bring the S0 interface up unless I put the Router into loopback. Verizon showed up 2 days later when I was not there (I swear they plan it that way) and said that the wire was incorrect for...

Hi All,I have 2 Cisco routers and want to setup a lab at home. I also have 2 DTE cables to connect to each router.Is it possible to connect them together by using a Female to Female X21 interface extension cable ?? I know someone who can make this ca...

Below is a brief log of up and down links on an LRE 2900. My next step is to change the speed and duplex to auto from 100 and full, my question is if I change the speed and duplex at the remote location first am I going to be kicked out or disconnect...

Is it possible to configure netconfig to use tftp and snmp only instead of telnet to update the configuration of the routers.ThanksKenneth

Hi,On a HSSI interface, we are seeing that the OUTPUT BUFFER SWAPPED OUT counter is incrementing at a very high rate (it was 48233551 when we checked last time). As per documents, this value means "Number of output buffer allocation failures". From ...