Other Network Architecture Subjects

Im trying to link my off HQ to the branch off at a remote location via VSAT. Im using 2 vsat modems, 1 for transmit the other recieve. Im using my s0/0.1 as outbound int and s0/1.1 as my inbound. See my running config below interface FastEthernet0/0 ...

Has anybody experienced slow response with the CNR GUI when connecting to a CNR server across WAN links? If I attempt to config a secondary zone on a remote CNR server I get a 2 minute delay opening the DNS@ns2.x.x, chosing Add, inserting a name and...

Appear the following messages on the GSR12008Jul 22 11:28:34.218: %MEM_ECC-3-SBE: Single bit error detected and corrected at 0x5443E720Jul 22 11:28:34.218: %MEM_ECC-3-SYNDROME_SBE: 8-bit Syndrome for the detected Single-bit error: 0x85.The following ...

Need help finding OutOctets for a cable modem from the CMTS perspective.I am able to read the number of octets that have currently been sent upstream from the cable modem to (through) the CMTS. This can be found from the CMTS’s docsIfCmtsServiceInOct...

Hello,I need to configure encpsulation on subinterface on cisco 1750 router but couldn't get the command under sub-interface. Which IOS coulc i blast on the router to enable this feature?.

When I'm attempting to run a hardware or software report, I can only select 50 devices at a time - Can I change this number? If so then what is the process? The 50 device max is a problem as it stands today.Thanks

Hi, I am running a Cisco 7200 router with IOS 12.3(1a). I tried to follow the instructions exactly for installing the QDM (Quality Device Manager) 2.1.2 (latest version) but I could not get it to load.Instructions say to copy the file over tftp onto ...

Hello to all,Is there any direct command to find out the physical/hardware health status summery of all LAN WAN ports on router or hardware problem, except normal show int and controller commands.

Hi:I have one question about GBIC ZX and TX power output.When I connect a power meter with attenuator. I read 2.02 dbm in TX output.But when I connect to RX input (of the same GBIC) the TX output of another GBIC ZX the power meter show to me 2 value ...

I found that Catalyst 2900XL/3500XL have this feature , but can cat2950 implement it ?

I have one remote router on one site with 1 isdn bri interface, and two routers on a central site which are on the same LAN and have an ISDN interface as well. I want to have a primary isdn link to one of the central routers to gain access to the cen...

When primary line on a router fails, dialer watch causes backup to dial out. But: when there is no traffic on the line, the backup line will go eventually down (idle-timeout kicks in) - immediately after the backup line goes down dialer watch brings ...

Folks,i've recently taken over as network manager and i have a general query on DDRWe have a number of isdn lines with ddr configs, pretty standard stuff mostly - my query is that my mail team (lotus notes) seem to be under the impression that the is...