Other Network Architecture Subjects

Just upgraded a 3550-12T to version 12.1(12c)EA1 and the upgrade was successful except now when I try to access the switch thru my browser using CMS, I get the following error.ErrorNone of the version files were JRE-version-compatible.I was able to ...

Hello there,I want CWW to run on a port other than 80. If I change the "Port 80" statement in the httpd.conf file, CWW is listening on the new port, but it's not working properly anymore.

Is anybody using the combination of 6500(7600), flexwan and pa-mc-stm1? I'm interested in the ios release you are running.

Hi,Can I force to get down an interface when another interface go down? Is there any command to do this one?Thanks.

the command for static ip route says" next hop or exit interface".when do we use the exit interface?is it only used in wan?can we not use it in lan?when is the next hop used?why?

wondering if anyone can help me with the following scenario....if a router learns 2 routes to a destination network, one from EIGRP (=admin distance of 90) and another from eBGP (admin distance = 20); which will it prefer?will the router in this case...

Hello,A customer has got 3 2948GL3 (and others equipements like 3548 & 3524 XL) in his network.The version used on 2948GL3 is :IOS (tm) L3 Switch/Router Software (CAT2948G-IN-M), Version 12.0(14)W5(20) RELEASE SOFTWAREAll equipment are well discover...

Hi ,There default ports given in the IOS .We can use both to refer those ports by names as well as port numbers .Can we customize it and to the defaut list ports by names not by numbers. or I want to use it use customized ports used for my applicatio...

Can someone please guide me how to implement provisioning of bandwidth per IP or range of IP in support of service level agreement (SLA). Let's say a certain IP will be given a commited bandwidth and burstable bandwidth available on the interface. Th...

Hello Friends,I would like to appear for the Network management exam.If anyone can help me out in giving me the following details:Prerequisite for the Exam:Recommended Books for the Exam:I had searched for the books in the cisco press site but in vai...

Catalyst 6509 MSFC2 error message..6509-MSFC2# sh logDec 13 07:39:16: %MISTRAL-3-ERROR: Error condition detected: TM_DATA_PARITY_ERRORDec 13 12:03:47: %MISTRAL-3-ERROR: Error condition detected: TM_DATA_PARITY_ERRORDec 13 20:34:08: %MISTRAL-3-ERROR: ...

if a forwarding (or block) port keep in forwarding ( or block) state after a topology changing, what is it state during the topology changing?

I have enabled NT authentication in CW2k... how do I control access within CW2k using NT domain groups, etc? Is it even possible?Thanks, JS

What would happen if the RPF check found two equal cost paths to the source in the igp routing table, and we were process switching. Will there be load sharing?