Other Network Architecture Subjects

Hi SupportI can view real time traffic on CiscoView's for a router. But how can I generate a 1 wk traffic report on all 14 router's serial interfaces? Pls help, thanks.Thks & RgdsZee

Hey guys,Just started studying for my routing exam and was wondering if someone can explain the concept of adjacencies when discovering routes? Is an adjacency formed simply when two routers are directly connected?1---2| |3---4Hence would...

What is the difference between the speed of an e1 port and a 2meg serial port

Can the Ciscoworks 2000 RWAN, LMS and Cisco WAN manager run in the same Solaris server ?If yes, what is the hardware requirement for these 3 software ? I found the minimum server requirement for these individual software in CCO. If they are in the s...

System Bootstrap, Version 11.1(10)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Copyright (c) 1997 by cisco Systems, Inc.C1600 processor with 6144 Kbytes of main memoryprogram load complete, entry point: 0x4018060, size: 0x1e1568%SYS-4-CONFIG_NEWER: Con...

Hi,Since I'm having problems with VHM running with Campus, I want to move Campus/RME to another server.Anyone put Campus and RME on the same server as Compaq Insight Manager (CIM7) ... or vice versa?I'll be using a Compaq DL380 with 1.5GB RAM and 1.3...

Hi all,Just one question, I use the MSTP on 3550 platform just to use the RSTP fonctionnality, as the RSTP is not yet implemented on IOS.My question is: If I put all my vlan's in on single MST instance, do I have one spanning tree per vlan or not ...

Hi!Is it possible to use WIC-2T and NM-1E2W together on speed 2Mbit/s?Thanks

I’m setting up a new building. I have two 6509s with RSMs running full IOS 12.1(8b)EX5 set up as a pair using hsrp. There are 8 floors in the building, two cat 4000s per floor, and 1 vlan per cat 4000. The servers are on their own Vlan. My server...

Please how do I get the DFM to send only critical messages. Also my fault history database engine will not work eventhough i have installed the patch. Please help.Thanks

I'm trying to export device from CW2K to RTM 1.3I was reading on RTM FAQ :http://www.cisco.com/en/US/products/sw/cscowork/ps2803/products_qanda_item09186a0080094b24.shtml#importIt says "Caution: To avoid undesirable result, only use the Import utilit...

Hi How do i configure SNMP trap on my router ?I want all trap messages to recive on my server.What is OID ?

I want to be able to dial into a 1605 router. Can this be done via the console port as there is setting's there regarding a modem.Hope someone can point me in the right direction or simply tell me it can't be done!!Best regards,Darren.

Hi,I have put a route map for a transparent http proxy on two Cat 5509s. Works fine. Unfortunately it breaks NFS altough NFS should not go through the Acls.IOS is 11.3(6)WA4(9).Route map looks like this:route-map proxination permit 10 match ip addres...

hello, the command for static ip route says" next hop or exit interface".when do we use the exit interface?can we not use it in lan?is it only used in wan?can u answer my queries? smita.