Other Network Architecture Subjects

Hi, I have a CW2K - RWAN 1.2 install on a Solaris 8 machine, and couple of routers over the wan environment. I am using the IPM for performance monitoring and statistical analysis. So, my question is, does the IPM provide a feature that can customize...

We have a 3550-24 PWR and also RPS300 for redundant power. My question is when I unplugged the regular power of the 3550 the RPS takes over but when I plug the regular power back in the RPS is still the one that is powering the 3550. How do I make it...

This an update to my earlier post concerning the crashes on AS5300When it start going down, we get a series of the following:6d20h: %SYS-3-CPUHOG: Task ran for 2472 msec (94/60), process = ARP Input, PC = 60303BB0.-Traceback= 60303BB8 60352448 602EC7...

On a new recently installed 2620 i have encountered a problem, any traffic through the fastethernet module - in or out - causes the router to re-boot with a segmentV exception. The router has a single network module with a wan card installed on it, t...

I have two 3548XL switch connected in stack through 2 FE port (I don't know if it is a FEC). I have NO VLAN defined. I need to put an IDS to monitor all the traffic passing through the 2 switches. Do I need to define 2 SPAN port, one for each switch ...

We are using a C7206VXR, ios 12.0(4) and got the message POT 1E1-3-FWV , ports on modul was disabling,enabling,disabling until router was reboot. Since reboot, this message wasn't occurs again. What means this message. (No docus found on cco). Thanks...

I am having problems using CW2000 on an NT Client. I can log in to CW2000 OK but I am not getting any of the menu items for navigation. I get an hour glass on the menu side as if the system is waiting on something. Is this a service pack problem ?...

Hello,I have to upgrade a MSFC2 Board, Sup1A-2GE with DRAM from 128 to 256 MB.1. Router shows only 128MB DRAM, with ios 121-13.E2. Maybe memory is defective.Are there any issues about ?2. BUT I have an (helpful) information about config-register on M...

Current setup : cisco router 3640 connects to a Frame Relay with traffic shapping and VOIP (Hoot N Holler). We need to add a second P2P circuit to the same router for redundancy. We are running Eigrp. If I use the varience to load balance between the...

On Solaris , CW 2001 LMS(NNM on the same server) DFM Trap Notifier dosn'twork when CW comes up.It start forwarding just after a disable/enable.Does anyone has figth agani this?

Is there a way to automate the exporting of the user tracking data to a text file? I am running Campus Manager 3.2 on a windows 2000 server.Thanks.

I have inherited a network where the cables have either been mis-labeled or in some cases not labeled at all. How can I find out what switch port a device is connected to?

The election procedure of the DR and BDR says that routers declaring themselves to be the DR cannot be elected BDR.Why ?

I Have 4 switches 2950 connected each one with the others three and one of them as a root. 1.- Can I activate UplinkFast in order to provide fast convergence in the network access layer after a spanning tree topology change?2.- Should I activate Upl...

Can anyone tell me how I would go about working out the latency of two C3550-12G and four C3550-24 switches accross a dual fibre ring. Each switch has two G5484 connections, one to each fibre ring.