Other Network Architecture Subjects

I am trying to recover a 6509 (sup1 mfsc2) in native mode. I am getting the same output as per website http://www.cisco.com/warp/public/473/14.shtml when I get to step 6 where I have to xmodem the bootloader file onto the flash (of the RP) it says to...

My network... My wide area network is connected through leased line from main office to remote side, as contingency to the connection setup I use the Async serial ports of a router (2500) to dial up whenever the leased line is down whereas to re esta...

I have two Cisco routers on LAN interface with outside segment of PIX525, both terminating T1 connections to same client site. Want to be able to load balance between the two. One is on 192.168.124.110 and the other on 192.168.124.111, firewall outsi...

I have a 2600 router connected to a T1 circuit. The other end of the circuit will be sending data using DLSw. Is this supported in the Cat4k box and what, if any, special config will I need to do on the Cat4k?Thanks.

We are having an issue at certain times of teh night when our HP servers are unicasting packets to the whole network. Can I limit the port the HP is plugged into? It is bringing a 1400 node network to the it's knees..

Hi I have AS5300 and i need to control BW assign to this equipment because it share internet access with a corporate LAN. How i can to make that

I had originally configured two 2610 routers with one having 192.0.100.1 address on the Ethernet port and Serial Port unnumbered and the other having 192.0.101.1 address on the Ethernet port and Serial Port unnumbered. The serial port is a 56K csu. ...

Hi I'm having trouble finding what this error message means on a 3508 switch. Its working fine and no network probelm can be seen. Any help on this will be greatAccessFrame from non-ram access portRAM Access Frame from non-ram access portRAM Access ...

Hi group,I'm trying to get clarification on how much Token Ring is in the latest labs and tests for certification. In the CCNA practical studies guide (April 2002) the lab has (2) token Ring routers. I had heard, from an earlier post, that Token Ri...

Hello sir,When i use ciscoview. I point to the graphics of ce1 module in ciscoview. I wanted to use the monitor function (by click the right button). But it seemed I can't monitor the logical interface's traffic. I can see zero traffic on ce1 physic...

I am looking to setup a connection between two 1720 routers via an ISDN BRI connection. This connection will be 24x7x365. I am looking for examples of configurations. Do I want to do DDR?Thanks!

Can someone post a config on how to configure 28 Full Ts on the PA-MC-T3?

CW2K running on Solaris. If the causer account has been compromised or I want to change the password for it, "after the install" what is the proceedure?

I have two 3600 series routers I use for provisioning my DSL customers. I noticed something interesting today and was wondering if any one can explain it. I cannot trace route from either 3600 to a any user's IP, however I can trace from my workstati...