Can I configure an 6509 MSFC (primary) and an 7206 (secondary) sitting with in the same campus. I'd like to have the 7206 become the active router when and if the MSFC goes down. Can this be accomplished? I thought for HSRP to work correctly HSRP dev...
We have one cisco 3640 router with 4 port BRI (S/T) card ,, and one cisco 2522 router with one port BRI (S/T) card ,,, We have four Siemens ISDN line with basic-net3 switch type ,, problem is that ,, wehn i plug in my ISDN line in my cisco 2522 route...
I have a Catalyst 5500 and a Catalyst 2900XL. The 2900XL is linked from ports f0/23 and f0/24 to 5500 ports 3/3 and 3/4. Assuming that all the duplex, speed, and VLAN settings are the same on all four ports, should the configuration be like below?550...
I have 2 cisco 3460 with VWIC-1MFT-G703 AND CAB-E1-RJ45BNC. I want to test the config and hardware before I install it onsite. Can you just cross the TD and RD BNC cables and add a clock at one end?
This is a brand-new network, there is only one laptop at each site for setup and troubleshooting. The configuration is this:All routers are 1751s.Central Office: 3 serial cards1 goes to Office 1 over a full T1, PPP, Private address at each end (192...
i got a router which enable multicast service on it , i find there are high cpuutilization after enable it , when i use command " show int sta " reveal all mulitcast service being handled by CPU , Is there any way i can use to decrease CPU utilizat...
I do not know for the life of me why I can't get this to work correctly. I download the new image to flash and it says it is copies successfully. When I restart system it can not boot from the new image and falls back on the old image. I have done th...
After installing a CISCO 6509 the AS400 entries in the ARP cache tables on the routers began dropping out or showing up incorrectly. The problem was resolved by adding permanent entries for the AS400's to the ARP tables.CISCO says this was caused "by...
I am trying to get a 7120 router to send a notification to HP Openview NNM when a BGP session drops. I have two T1s running BGP and if the BGP session drops I want the route to send a trap indicating that it has lost a connection.Thanks,Doug
I was on the phone today with a Cisco rep. and an AT&T rep. at the same time and neither could come up with a reason for my equipment not resolving certain ip names or numbers. Sometimes I can type in a site (i.e. <A HREF="javascript:newWin('http://w...
Has any tried running CSPM 3.0 on a Win2k box? Has it worked, any problems? Does any one know if Cisco is going to release a version for Win2k specifically. Or should I just stick with a old Winnt Install? Thanks for any Ideas or comments.
My company is currently using an entire class C IP address scheme for their LAN. I added a secondary IP address to the router for a new Class C IP address scheme. I need devices on the new IP address scheme to talk to devices on the old IP address ...
HiCan someone please point me in the right direction to find out more information on assiging dirve mappings and logon scripts to users who dial in using a cisco router with ACS authentication in a microsoft domain if indeed it is possible to do.Than...
I just ordered Verizon DSL service at my home. The equipment (Westell DSL Modem) has arrived but the DSL service activation date is not yet reached. I intend to set up a local LAN which use only one DSL connection.I used to have Qwest DSL service b...
