Other Network Architecture Subjects

Hi All,I have a problem enabling our 3 interconnected sites to EIGRP routing.Please refer to my attachment for detailed view on our network.Problem scenario:1. No problems when eigrp is enabled between Router A & Router B:config use on both routers:r...

Hi,Could someone give me an advice for a suitable loop free EIGRP configuration w/c I will be applying to our 3 interconnected intranet sites, currently we're on static routing configuration to every intranet connections.Also i would like to keep our...

Hi all, can anyone tell me what minimum hardware you need to run mpls tag switching on ? and do you need to run a routing protocol for this ?

Hi AllMy question is that if The command "set ip defualt next-hop X" and "ip route 0.0.0.0 0.0.0.0 X" is some effect ?thank you .

i need your support to know model Router with BRI interface

We currently use two IPs for general purposes (website, e-mail, ftp, etc.). One IP should get priority against the other for incoming traffic.Is there a way to use the QoS feature of the Cisco 1712 for this task (or an other solution ?) ? How can thi...

I tried to find the following info, but no luck.Is that mean the ADSL line has no dial tone?ro1-10000#sh dsl int atm 0/0/0ATM0/0/0Alcatel 20190 chipset informationLine has not yet been activated.Modem Status: Down (DMTDSL_DO_OPEN)DSL Mode: ...

Hi all, can anyone tell me when we use the wizard on the cisco asa to create a vpn tunnel, does it automatically add a nat0 statement so it no nats the given networks, and also does it do a seperate access list for the encrypted traffic, if i go onto...

Hi All,Can we say E1 an a leased-line is both are same / any difference is there.If my company take E1 from one Service Provider then how can we get Internet, from where shall I took this service.Experts can anybody see about it.Regards,Naidu.

Dear experts,we have Head office to 7 branch officese connecting throu leased line(v.35).head office we dont have highend router so we r planing to connect 2 1720 routers.in first 1720 router 4 links r terminated and second 1720 router 3 links r term...

DearI have issue with my network.Actuallty I have 6500 Switch with Firewall Moduler. and connected to DHCP Server <Mirosoft Version>. And the VLAN 10. is behind the firewall and from there connected to DHCP Server. WHen the user try to get IP address...

Is there a way to have the router be able to boot up without the CF card installed? It seems when I take the card out the router will not find the IOS. I am new to the 2800 so I am trying to figure this out. Thank you.-Nick

hi,do you know how can i enable dhcp on an 837 router?

I am sorry for such a basic question, but I am still getting mixed signals:Between like devices: use crossoverBetween different devices: use straight throughHub is like a switch and router is like a PC for this purposeThat makes switch-switch using c...