Other Network Architecture Subjects

All, I am trying to implement STP load balancing from shop floor to core network.vlan 13 (voice) over 54 wlan bridging linkall other vlans (data) over terascope linksCould you guys confirm attached topology (viso)

Hi all, can anyone tell me, when creating address pools on my asa for the ip sec clients, why do they have a mask of 255.255.255.255 ?

We got some Cisco catalyst 3560 that we want to control the bandwidthon the ports. Can this be done, and how do i do it?Ive got 3550s that can do policy-map with the interface command;service-policy output(and input) <policyname>But 3560 only seems t...

Hi,I try to connect to the LAN switch by following the instructions with DHCP-enabled PC. With any PC, broswer, OpSys when I type the a browser cisco.com the result is an attempt to access http://169.254.0.1/espress-setup.htm which is expected. But "...

We have several remote locations that we just installed Aironets at. All the locations are setup to forward DHCP packets to our centralized DHCP server(s) via ip-helper. Here is the situation. I took a wireless client to location A (10.10.0.0/16),...

Hello! I'm trying to replace a Windows Server using a 2821 router.INITIAL SITUATIONServer --- 2950 --- router- Server: 10.0.6.230/24- Router: 10.0.6.10/24- The router interface can be pinged from the serverFINAL SITUATION2821 --- 2950 --- router- 282...

Can we use XFP transcivers in Cisco WS-C3560G-48TS-S SFP port.

I am wanting to setup my backup router into network. Currently, I have R1 (6500) plugged into SW1 assinged to VLAN 10.I want to connect R2 into SW2 (6500)but it must be standby only....NO Load balancing.I currently am config'd with even / odd vlans ...

Hii am running two Microsoft servers. One is live and the other is in DR site, they are currently on differnt subnets, and for them to cluster, they send broadcast. what can i do for this two servers to talk to each other.changing ip's on the router ...

Hi.I have 2 vlans (voice and data) in a CE500 and a Cisco1721 to route inter-vlan and to access mpls network.I cannot associate ip address in my vlan's and i cannot change the port 24 to port trunk. I create to subinterfaces in my 1721 (172.16.19.0/2...

Hello,I just installed a 6509 running ios. This 6509 connections two server irons (Foundry, switch like). On the 6509 I have multiple servers connected to it. I can ping all my networks but one. 10.7.1.x/24 (from these servers connected to the 650...

Can anbody tell me what the latest software release is for this switch? I have been looking through the software section and I can only find 12.0.5...is that right? Is there any other software that I could put on this? Any help is appreciated! Thanks

I am trying to get Radius work on our cisco machines. However when i debug i get this message "Radius Module not initialized".What am i missing, a piece of the config is entered below : aaa new-modelaaa group server radius TEST-Radius server 192.168....