Other Network Architecture Subjects

I have installed new NIC on my PC and configured attached ip and gateway. Also configured router with below configuration. I am able to ping from PC to router but not able to ping from router to PC. any thing i am missing?Router#sh run int fastEthern...

Dear Team,We used the following commands to check the throughput on our Cisco Asr 1001x router, and the outputs were as follows. However, their throughput different. When we use the show license command, throughput is shown as 10G, while when we use ...

Hi,I have a router c1104 with feature securitk9 (VPN crypto) and enabled license with on-prem license server..we tried to install the new version of IOS with classic mode, but when reload the router with the new IOS the router didn't keep the license...

Just trying to understand when the token refresh occurs for the QoS shaping mechanism. From my understanding tokens are put into the Bc token bucket (single-rate three colour bucket) at the Tc rate? Is this correct? Or are tokens put into the bucket ...

Hello friends,I am trying to understand the command "ip sla responder udp-echo ipaddress a.b.c.d port xx" but I have a doubt, the ip address (a.b.c.d) in the command refers to the local IP address on the device where it is being configured or it is t...

Hi everyoneI have a issue when a endpoints get ip address from Switch 9200 and router 1921 their Dns record A and PTR doesn´t update, they keep old record and IP.Someone have configuring "Dynamic DNS Updates by a DHCP Server" in cisco swtich/router? ...

Running CML 2.2.3 latest and it does not seem like you can connect with python cml and virl2-client anymore? Been a while since I have used this but just checking if i was using the wrong thing or something these days? ➜ ~ cml upException raised whil...

Hello Community! I have a doubt in design ..What is the difference between put a sevice like OpenNTPD running on debian and located on Network Services layer versus put this same service in the Server Farm layer? What is the difference between those ...

Not sure where to ask this, but going to give it a shot.I'm a Network Admin at an ISP and I have several Cisco ASA 5505 series units, ONE of which has a booting issue.  I have included the full Console boot logs for reference.  To start, we see "5505...

Hi,please someone tell me the difference of switchport trunk encapsulation dot1q vs switchport trunk allowed vlan 

I am using Mobaxterm terminal emulator on a Windows machine, to connect to various HPC clusters. I also have a corporate VPN using AnyConnect. When the VPN is connected, I can access my company's machines, but SSH connections to external machines tim...

Introduction This document describes the process used to copy a configuration or text file to a router that does not have any file transfer access.   Problem The best way to copy a configuration/license or any kind of text file to a router is to use ...

I have Cisco 3550-12T Switch and I wish to remove some vlans that are not in use.This is the error message I get when I use no vlan command:Sydney(config)#no vlan 66Error exiting config-vlan mode 39: NV storage failureI am not sure if this is a memor...