Other Network Architecture Subjects

I am trying to create a SVI on a catalyst 3750 switch but when I do a show int vlan , it indicates the line protocol is down.What could ve the problem and how do I get it up?Here is my config:Switch#vlan databaseSwitch(vlan)#vlan 700 name ManagementS...

I have a cisco 2924M-XL switch which is connected to a 2950 switch. I desire to have a trunk between the 2 switches. The problem is the 2924M-XL supports only ISL and the 2950 supports only dot1q.I tried to upgrade the ios on 2924XL but no copy comma...

I want to delete the VTP domain name on my 2950.Sh VTP Status display :VTP domain : CACEVTP mode : transparentTry to use command line vtp domain "" and having this messageOperation failed; Bad domain name lengthWhat is the way to set a null domain na...

Hi all, Can someone tell me if I wanted to route say the first 32 machines in the 10.1.2.0 subnet to say 192.228.1.1 what route would I need to put in, would it be 10.1.2.0/27 ?cheersCarlos

I have added the following to my VLAN in order to see ALL traffic passing both ways:access-list 110 deny ip 10.0.0.0 0.255.255.255 anyaccess-list 110 deny ip 172.16.0.0 0.15.255.255 anyaccess-list 110 deny ip 192.168.0.0 0.0.255.255 anyaccess-l...

simple question: I can't remember how to resolve the following issue on my console connection via a term server - i connect in and then observe the following 'echo' when entering a command:sshh rruunneach character gets 'echoed' i seem to remember ...

Can a range of IPs be excuded from NAT?

Hello,I am looking for some clarification of CEF switching behavior when using the following topology. 2 layer 3 switches, A and B, directly connected via a dot1q trunk and 2 hosts, C and D, both connected to switch B. Host C is in VLAN 10, Host D is...

We can't get any translations to show on our router when connecting from the outside. I was looking at the config and was wondering if the sub-interface portion was correct. I am curius to know that if I put an IP on fa0/1 (instead of fa0/1.1) if thi...

What is the easyst way to configure an catalyst 3750 switch to limit traffic going to an ethernet port.I want to adjust the throughput of an 100 mb ethernet port so that only 5 mb is going through.I was looking at traffic policing and shaping. But i ...

Hi All;I have 2801 which I downloaded second IOS image. How can I load the router with second IOS image but keep the old IOS in the flash?ThanksAlex

Hello,I urgently need to know the differences between the 2950 EI and the SI.I need this info urgently in order to make a purchasing decision.

Hi Everyone,Would anyone know what the maximum number of T1 the can be installed into a 2851.Also, would anyone know what the break-even point would be when to install a T3PS: This is for a voice project. Lines will be used for Voice only.Thanks.-- D...

What is the algorithm used to distribute traffic between the ports of an etherchannel on the 3550? We are using the default distribution method of source-mac. Is there an IOS command I can use to see which port the traffic is using?