Other Network Architecture Subjects

Hi I have a Cisco 2950EI and while the rate limiting is good in ingress, I wanted to also blend in prioritization in the prority queue. However in the policy map I would like to make bsd10 traffic low priority, while the rest is high. I typed some st...

Have tried to connect a little cute 2940 into our existing infrastructure without any success. My problem is that it cannot take any vtp domain information. Try to set it as a client and the config with password etc is the same as the other 2950 and ...

In one of the CCNP books it states that"VLANs should not extend past a distribution switch onto the core."If this is so, how would you connect each VLAN to a router (which most likely be accessible only via the core switch)?I am hoping that this stat...

Hello all,A company I work for is hosting an application at a popular managed hosting provider and are using the css11501s to do layer-5 load balancing between a set of application servers.We are seeing a strange error that seems to occur when the fo...

Clients with Intel Pro 100 VE or 8255 can only connect to switch at 10mbps/half (set manually on client) except 3com 3c905c autonegotiating at 100 full. Client with Linksys EG1032 autonegotiates at 10 full. Portfast is enabled and setting the speed...

He colocado un snnifer en la red pues el procesador del router llega a %100 y tengo excesivas colisiones en la interfase, este equipo es el gateway de la red, lo que me muestra el snnifer es mayor trafico broadcast con una mac 020100000000 y alto tra...

There used to be a tool Cisco had to help converting configuraitons from hybrid to native.Does it still exist or do you have to do everything manually?

I have a 1720 with a WIC (T1) Serial0 interface and a FastEthernet0 Interface currently performing NAT and routing several public IP's to internal servers.I need to know how to properly setup a full bridge between the ISP (T1) and the Ethernet interf...

This EtherChannel config is for the same channel group 1:interface Port-channel1 description to 6509-Core-A P1 ip address x.x.x.x y.y.y.y ip route-cache flow ! interface GigabitEthernet1/1 description to 6509-Core-A T1/1 (P1) no ip address ip route-c...

The topology is simple. Three 3550 switches as the backbone tied together using spanning-tree layer 2 wire speed switching. Very simple stuff there. Introduce 3745 access routers, one attached to each 3550, each loaded with 16port ESW, 1 GigE GBic...

- Sho proc on 4000 shows 20% steady utilization. and the following two taking up most of this util. What could be wrong. I donot see any error messages in the log:25 19693619442955991267 666 15.13% 14.19% 14.54% 0 Cat4k Mgmt HiPri 26 6543...

Folks, Has someone configured one of their core 6500 switches in HSRP mode as DHCP server for the phones. We tried to do it with little success.ip dhcp excluded-address 10.2.12.1 10.2.12.150ip dhcp excluded-address 10.2.13.1 10.2.13.150ip dhcp ...

Hi pls look at attached diagram for reference. Router A is active, Router B is standby. Question is what happens when fibre link 1 (between switch A & B)fails but fibre link 2 (between switch C&D) remains active - which of the two router will be acti...

I have a problem with my Cisco Router of the 800 series (Cisco 827) - it its not possible to have access (ping) to the PC behind the Router, on which a mailserver is installed.I want to have access from an outside PC on the www to this mailserver mac...