Routing

Hello all, I have something that seems pretty straightforward that I'm trying to emulate.  I'm trying to assign a DHCP address to a spoke tunnel interface on a DMVPN setup.  I have the DHCP server on a separate router (172.16.0.3) and the hub acting ...

I am trying to configure failover with a gateway of last resort. I have 2 routers and each have there own ISP connection. One is our primary, and the other is our backup that also routes all of our wireless traffic. We have route-maps setup on the co...

Hi all,We have a few Cisco 2911's running 15.0(1r)M15.  We have Brocade FCX648S's and a TurboIron 24X that were just deployed - they will have VoIP phones connected to them.  The folks at Brocade have said that they just need the command "trust dscp"...

When Ebgp & Ospf is configured on router and we have to ospf route should prefer rather than ebgp route???

Hi, i'm new at cisco devices. I recently install a router rv325 with vlans. All the vlans can access internet without problem. But through the router, i can't access some website. I am not sure but i think it is a problem with the used port. For exam...

Good morning everyone.   Please, i am trying to configure a GRE tunnel for a client from the clients router to connect to another router (provider). After configuration, the provider keeps telling me that the configuration is wrong.   Below is their ...

Hi,   I have one ISR 4321 and I would like to use it to connect 2 ISPs. One Isp has PPPOE and Vlan Trunking connection and One ISP has Dynamic or Static ip public.   This router only has 2 Ports 10/100/1000 so I need one port more. 1 LAN and 2 WAN.  ...

With Sandeep SharmaWelcome to the Cisco Support Community Ask the Expert conversation.  This  is an opportunity to learn and ask questions about issues encountered while configuring and troubleshooting Border Gateway Protocol (BGP) across various Cis...

Hello Experts,  I'm stucking with the task of tonight. I have a topology like this:                                                                          (.2)                    (.3)                                                                 ...

I am wondering how to do this properly because I have never done this before and was wondering if someone could help me understand how to with an example or anything? I have tried to figure this out but I am not sure if I have found the right way. Wo...

Folks   In our school we have a Cisco 5508 wireless controller with 45 AP's. In the closet we have a C2960X switch.    In one room, we need to have a single access point (VLAN 2) and a projector (VLAN 30) connected to the same switch port.   I can't ...

Hi, just want to ask some help for some codes/lines. Here's my situation, the client currently has 2 devices:   1. Cisco ASA (Main branch) 9.1(6) 2. Cisco Router 2801 with IOS ver 12.4(3d)   They've decided to decommission the Cisco Router 2801 and r...