Routing

Hi,I have an ethernet interface on a ASR1006 router configured with qinq, outer vlan tag 150 and inner tag of any.The interface will recieve traffic from multiple inner tags and DHCP with devices connecting to a dhcp server to farm out addresses.What...

hi, i have created following topology of frame relay. create serial sub-interface 0/0/0.1 multipoint link on R1 and assign three DLCI to it for other end three routers i could ping R2,R3 and R4 form R1 and all frame relay PVD has been activated as pe...

I am using Chris Bryants toplogy for a 3 router Hub-and-Spoke through a frame switch setup with a couple extra routers: The Frame network is running RIP, a router connected to R5 is in EIGRP AS 100, and a spoke has several different OSPF Areas (incl...

Hi,  There is an issue reported in my office network where our remote location is facing internet sites access issue when diverting on the backup internet link. However, the internet works fine when traffic is enabled to pass through the Primary int...

Hi Do you think command "neighbor 6.6.6.6 update-source Gig0/6.51" is necessary? What is significant ? If it is loopback, i think it is router bgp 6111  neighbor 6.6.6.6 remote-as 655  neighbor 6.6.6.6 update-source GigabitEthernet0/6.51

I'm trying to backup config from ASA 5505 that is currently connected to the network and restore it on a backup ASA 5505 which is not connected to the network yet.  Is there a way to backup the entire configuration including Access and NAT rules, pol...

Have an older WAP-200 that I'm trying to get to the utility menu. The device is connected to my switch and one of the ports goes to my desktop.  When I enter the URL  192.168.1.245, it cannot find it.  Any suggestions.

Hello Guys - I am trying to figure out why static default route is not getting redistributed to any peers (eBGP and iBGP). However, other static routes are getting redistributed. Can i know where is the issue. Thank you in advance Router-02 #show run...

Hi Do you think command "ip pim sparse-mode" can work in ASR9K? I typed it under interface, but it cannot work. Anyone can give some suggestions? Thank you