Routing

I've come onto problem switching on BFD on ASR1k. after applying configuration on router bgp:  neighbor y.y.y.y fall-over bfd single-hop show bfd neighbors vrf 1001 details show nothing ASR1K1#sh bfd neighbors vrf 1001 details ASR1K1# Please see bel...

Hello. I'm planning a Network re-design. There will be a dual-homed internet connection(same carrier), terminating to ISR 4431s. A pair of ASA 55xxs will sit behind the routers. Palo Altos will reside the next layer in. - Where is the ideal locatio...

Hello , I have a branch office with Cisco 1941 router. As the branch office is in remote location there is no feasibility of MPLS. We have taken broadband internet connection in branch office. To start the internet connection i need to configure PPP...

A partner will bring an MPLS circuit to connect our sites. One of the requirements is to tag the packets since we will be having mixed voice and data on this MPLS circuit. They said they will enable COS on this circuit so as to prioritize voice over ...

Hi Guys, Can you take a look at this scenario and provide some feedback. We have this following type of QoS policy applied to the Cisco887 for use with VDSL. policy-map UT class UT  set dscp ef  priority 3000 class class-default  bandwidth percent ...

Hi, Which speed do we need to select in Nexus7K? After typing speed, I got several choice. Please see the below, Why do we need to select them? Thank you switch(config-if)# speed ? 10 10Mb/s 100 100Mb/s 1000 1Gb/s 10000 10Gb/s 100000 100Gb/s 40000 4...

Hello, I am implementing QOS on cisco ME-3600X-24FS-M and i have problems when i want to attach the service policy on a physical interface To simplify i have juste 1 class-map in 1 policy-map.. "Access-group"does not work.. : mpe1#sh class-map  Cla...

I have a few dedicated server clients that use excessive amount of bandwidth, even on 100mbit port speed. I'd like to find a middle ground to keep things stable. Can someone please explain in simple, command to command terms how to set a rate limit o...

Hi, I have an ASA5510 that I have been training myself on to get more experience with CISCO IOS and I am having an issue routing traffic from outside to the DMZ (which is actually just a second network, I haven't actually created a DMZ yet). So I h...

Hi guys!! I've analyzing this case: I need to set the address on interface p2 of R1 to use as gateway for the /24 networks on SW2 - Can not plug SW2 directly to SW1 - Can not use VLANs - Using only Static Route (no protocol) [10.10.0.0/24] -...

I've having an issue getting NAT to work when the outside interface is a subinterface. I can't find any mention of this not being supported in IOS-XE on the 1001-x. It's also not mentioned at all in the IP Addressing: NAT Configuration Guide, Cisco I...

Hello all, I have to configure Router below. (I plan to use HSRP) I want you to advise me which diagram is efficient. Actually, I don't know what firewall use Layer mode (L2 or L3) -> this will be confirmed tomorrow. In this point, if you know wel...

Dears, i have cisco router 881 (4 lan port and 1 WAN) and i have real ip from ISP assigned to WAN port  (\30 subnet) , also i have real ip range from ISP (\29).. the question is: Can i specify one real ip from range to spesific device connected to on...