Routing

Does anyone know what ios i can run on my supervisor Iv engine. I just bought it and they did not send the flash with it. I have IOS for Supervisor 720,sup32 on hand right now..The IV engine is going in a 4500 chassis and needs to be able to support ...

Hello colleaguesThe problem is, that i have ~ 7-8 Mbps on 65Mbps link, but my service policy seems to drop packets according to queue size.In my understanding, policy map start to drop traffic only when congestion appear, is it so?same situation on A...

I have a network under a router(192.168.1.0/24). It is connected to multiple networks(x.x.x.x/xx). I need to allow ping from 192.168.1.0 network to all other networks. But none of the other networks can ping to 192.168.1.0/24. How can I use access-li...

Hi, I currently work for an ISP and also studying BGP. I was wondering when an ISP peers with another ISP what is the most common or best way for an ISP to advertise there networks. They obviously can't use the network commend as you could have 1000'...

Another tech and myself have been trying for several days to get a VPN working between our homes and our shop. We are both fairly new to VPN(ing) on Cisco and are unsure what we are forgetting to configure. The following is my config from my home rou...

Hi,I have a very difficult question that I need help.The network 2 needs communicate with the network 1, but the networks are the same. The solution is NAT subnet to subnet.I only can configure the router B.The network 2 knows the network 1 as 172.16...

Without license securityk9 on the router 2951 the interface SM-X-T3/E3 works fine, I see the CD led on and the status serial interface is up up. When I activate the license securityk9 after reboot the card status is down. 

When you have two routers at a client location and they are using HSRP is it ever okay to use the same Stateful Nat id?I am not at work right now so I can’t grab any parts of a config, however to my understanding when you are using SNAT you always mu...

Hi Experts, Just need your help again. I was trying to do some lab and I came across this weird behaviour with BGP outbound route-map. The diagram is simple. Please see attached diagram. Sorry for the very poor illustration. R6 has iBGP peering to bo...

Good day. We've got the following problem, but i cant solve it.We have: ASR1000-RP2ASR1000-ESP40ASR1000-SIP40SPA-10X1GE-V2SPA-10X1GE-V2!Kiwi Syslog ServerASR performs the function of ISG. The number of subscribers until 10000. This number is constant...

Ok, so I have dual sup's as seen in the show redundancy command:1001-1#show redundancyRedundant System Information :------------------------------       Available system uptime = 8 hours, 53 minutesSwitchovers system experienced = 0              Stan...