Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Routing issue with multiple wan

Hey All,I configured Cisco  1941 Router with two WAN. 1. ISP_1 i configured with Dynamic routing protocol (BGP), and ISP_2 (VSAT) is VSAT IDU.2. For ISP_2 we configured static router with 230 metric.Now the problem i having, when sent packet to my re...

cisco 2911 maximum pps/bandwith

Hello,We are installing cisco 2911 in a production enviroment and have not yet decided if it can handle the load or need to sit behind another router.This is the simple scenario:The cisco 2911 is intended to be the gateway which have WAN port connect...

support by • Level 1
  • 5924 Views
  • 5 replies
  • 0 Helpful votes

Basic QOS for RDP

Hi,Im trying to setup a qos policy to control bandwidth for microsoft terminal services so that it will always take priority over other traffic across a link on a cisco 1900 ISR.Could someone point me in the correct location for a qos novice or give ...

Resolved! Slow throughput on VTI

Recently I have configured a VTI interface between two 2921 routers.  The link between the two routers is 100 Mb but the tunnel doesn't seem to be able to pass that much traffic.  I've noticed some differences between the MTU and bandwidth in the Tun...

High CPU usage due Encrypt Proc

Hi all, I have a router with high CPU usage due:Encrypt ProcRouter cisco 1721 (MPC860P) processor (revision 0x300) with 57506K/8030K bytes of memory.interface Serial0 description #### TELCO bandwidth 128 ip address 200.94.44.65 255.255.255.252 no cdp...

Resolved! Eigrp metric calculations

Hi.here is my eigrp topology details. how eigrp get this fd distance, i try to solve this by using famous formula but i didn't get this 156160 value.R1#sh ip route 1.1.1.1Routing entry for 1.1.1.1/32  Known via "eigrp 1", distance 90, metric 156160, ...

feroz syed by • Level 3
  • 1756 Views
  • 13 replies
  • 0 Helpful votes

Resolved! router/firewall setup

Hope someone can make sense of how this will work.I was looking at gettin a wires only ADSL connection and put my own cisco ADSL  router at the end which is no problem.However i would like an ASA behind it to do the nat and terminate my VPN so i'm no...

Resolved! cisco nat, dynamic ip from isp

Hi!I think I understand the cisco NAT-PAT thing, but I try to manage this at my office with a 1841 router, and I don't know how to solve, that my ISP uses dynamic IP-s, and every 24 hours the public IP address is changing.Must I change the router con...

LOTS of Reading, Out of Ideas

Well, I did a lot of reading and a lot of searching (excruciating details below) and am still not able to get to my server from outside on the web.ssh dev.optuserv.com  (the domain I've set up) results in:ssh_exchange_identification: Connection close...

gmark by • Level 1
  • 771 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Overlapping 192.16.x.x subnets

HelloI acquired a comany comprising of 5 sites. I am phasing these onto my AVPN network which currently consists of 12 sites.The phasing aspect is being done by denying their subnets from my current routers and vice-verse.The new sites have re-ip add...

Cannot Access The Servers (Nat not working)

We are not able to connect to our Servers using Microsoft Remote Desktop from wan side. The Configuration of the router is:service timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname Branch!boot-star...

View All
Unanswered Topics
View All
Review Cisco Networking for a $25 gift card