Routing

Hi I'm trying to routing with IPv6, but I do not know anyone that can configure some advice?Sometimes when someone has a running config which geconfiguurt with ipv6 routing

Hi,Nowadays most of the top tier Service Providers configure their routers BGP peering based on RPSL queried from IRR Databases.They seem to automatically provision their configuration from rtconfig generated configurations. As I also have to maintai...

hi all,i have cisco router 3925 and i add\install HWIC-4ESW, as i sew on cisco documents you can  hot swap the hwic without reload the routerbut i it's not working at all.anybody know how to do it?thanks jacobCCIE#36456       

When I try to configure a voice port (like voice-port 0/0/0:15) after doing a conf t, it gives me an error of invalid input detected. What could be wrong?We are using a Cisco 3945. Please let me know if you need any show run/show ver outputs. We have...

                   Hi,As a part of troubleshooting we can check the loop for serial interface for WAN connectivity, which was provided by ISP for line testing,why we can't check loop for ether ports when we terminate a WAN connectivity to these ether...

Hi, Expert,Is there a way to mark BFD control packets in Cisco routers (such as ASR903) with high priority, so it gets treated with priority in swithcing network between two routers, in turn not suffers from packet loss and delay   ?  if it can be do...

Hi all, when looking at the interface below I see packet late drops and im trying to determine a few things,what causes output packet late drops? I'm assuming the sat on the output queue too long to be any good to the other sidehow is a packet determ...

(R1 fa0/0)<--->(fa0/0 R2 s 0/0)<--->(s0/0 R3 fa0/0)<--->(fa 0/0 R4)R1 fa0/0 - 10.64.0.1R2 fa 0/0 - 10.64.0.2R2 s 0/0 - 10.2.1.2R3 s 0/0 - 10.2.1.1 R3 fa 0/0 - 192.168.34.3R4 fa 0/0 - 192.168.34.4Routers R1,R2,R3 are in area 0Router R4 is configured a...

Dear all Cisco Experts,I just want to ask you that,is PBR only work on Broadcast Network or it will work on Point 2 point network also?R6 is connected with R1 R1 is connected with R2 &amp; R3 through Switch in same subnetR1 also have P2P connectivity...

Such a simple question in which I forgot. Is frame relay a setup companys use for thier own WAN or is it basically one way the ISP (internet) is set up that can connect to other parts of a companys (sub places)? so If I want to make my own practice s...

Hello,below the sh ver command of my core switch and i'd like to know if it supports netflow. because i've tried to issue netflow commands but it rejects it. thanks for your help and recommendation.Labib======================CORE-01#sh verCisco Inter...