Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

HelloDo you know what is the diffrence between SPA-2XOC3-ATM (2-port OC-3c/STM-1 ATM Shared Port Adapter) and SPA-2XOC3-POS (2-port OC3/STM1 POS Shared Port Adapters)?

I read in book (MPLS fundamentals) in section (Packet Forwarding in an MPLS VPN Network):- How does the egress PE router know which VRF the packet belongs to? This information is not in the IP header, and it cannot be derived from the IGP label, beca...

Hi!R1#show ip prefix-list detail p-filter-in | i seq 160   seq 160 permit 170.180.190.0/20 le 24 (hit count: 0, refcount: 4)R1#Could  anyone tell what is the meaning of "refcount" - variable counter in a  prefix-list ?? Hit count is obvious what does...

We have a point to point data connection at 30Mbps. Our QoS does not seem to be working since the line appears to think the connection is 100Mbps. The ethernet does come up as 100Mbps but the circuit is limited on the backend by the network provider....

darkmagex by Level 1
  • 665 Views
  • 2 replies
  • 0 Helpful votes

i am planning to buy 867vae router and i would like to ask you a few thingsthe configuration is through cli only(because i am not familiar with cli) or it can be web based ?the basic configuration  for dsl and routing  are preconfigured or i have to ...

crokkerrr by Level 1
  • 4112 Views
  • 9 replies
  • 0 Helpful votes

                   Hi everone,Please am looking for an Ethernet network module for a cisco ASR1006. A client has over 400 branches that will terminate on the router using rj45 connections.   please advice on the part number for this module.brsam

rahman001 by Level 1
  • 623 Views
  • 5 replies
  • 0 Helpful votes

Hey guys, I a junior level network admin, and working on my CCNA, currently have my CCENT. So I have been doing some study with Packet Tracer, and I am at a spot where I just dont know how to fix my problem. I have a router, connected to switch, and ...

Team,I have a customer with 2 sites connected by a T-1 between 2 2800 series routers. The main site has a uc560 (So static routes only). Connected to the UC560 is an 871 router that is owned and managed by the cable company. The remote location also ...

Hi All,Its good to be here again and I'll specially want to thank all contributors to this forum.Below is a sample configuration of my Router. I am trying to do QOS on the IPSEC VPN tunnel so that voice traffic can be given priority over other traffi...

tomocisco by Level 1
  • 1119 Views
  • 7 replies
  • 0 Helpful votes