Routing

Dears,I have Cisco 1841 Router with no WIC cards and USB.Image is ipbase and on the flash.  When it boots it gives the error and hangs - As suggested I changed the register value to 0x2142 but no change happened.Following are the capture from the rou...

I have not worked on the new VWIC cards lately. I would like to know how I can configure the serial IP address like we used to do in the older T1 DSU WIC cards. I do not see any interface that shows as serial. I have configured the controller as a T1...

We have 3 or 4 older sites that connect back to our central site using ATM over 2 T1s. This connection is for both voice and data. Equipment is a 3640 router and 8510 switch. These are our last sites on ATM, and we'd like to move them away from ATM a...

Hello,We have a network with metroethernet services. We are using Q-inQ tunneling to implement P2P services to interconnect two facilities of a same institution. We are growing and now we have a ring topology.  Until now we had disabled the MAC learn...

Hi All;Is it possible to be able to control the download traffic on the DSL router 887 Security Bundled, so I can give 30% of the downloaded bandwidth for the voice and 70% of the downloaded bandwidth for the data? So maximum data to take 70% of the ...

Hi there,I ve got a problem with 2 c3700 running IOS 12.3(4)T4.. Firstly the routing table couldnt be accepted (read the subnet thing that goes on when the broadcasts are sent) and i had to #no validate-update-source  but still i have no ping replies...

Using IOS image c2900-universalk9_npe-mz.SPA.151-4.M.bin to perform NAT with SDP, it works perfectly with RFC1918 address scope, but sends the originating ip address instead of the global outside address when the LAN is assigned a public range addres...

Hello,Simple question, if I create a trunk group (example trk6) on a core switch do I name the trunk group number on the edge switch I am configuring?Example I have a 5406zl I've created a number of trunk groups, do the trunk numbers need to be the s...

i have 2 routersr1---fa 0/0---ip address ----192.168.1.1r2--fa 0/1---ip address------192.168.2.1i have connected them by fast ethernet .can i ping them?if yes then how? if no then why???

Can't seem to get rid of extra characters in banners for either, login, motd or exec.  Do i understand the cmd properly: that the result will be the deliminiter at the start AND end of the text ?  Why can't I get rid of the extra "C" char at the star...