I have following senario.R1(AS2914)--------------R2(AS5689)------------R3(AS5689)----------R4(AS5689)----------R5(AS5689)R2, R3 and R4 are in same BGP AS.R3 is RR.If i do the trace from R2 to R4 loopback,Why is the AS number 2914 is shown ?...i think...
HiWhat is wrong with mac address and mac-ip mapping so in frame relay another numbering system(DLCI) is designed?Is it about the flexiblity that is provided to ISPs? (because mac addreses are constant)
Hi Guysi have 2 routers 2811 interconnected together ,1 of these router running in circuit with 2 Mbps over Internet the 2nd one use MPLS Circuit with a bandwidth of 4Mbps,how configure the routing to route over the MPLS while IPSec act as standbytha...
Hi Guys,We have a stack of 2960S, and have a new client that wants to connect via diverse fibre to both switches(From 2 switches on there side).We currently run MST and client is (currently) running PVRST.The 2 links will be trunks (With the same ~5 ...
I have a Cisco 3745 that is my internet router, I have a domain that directs the web address to the WAN IP address...Can I set up my 3745 to forward incoming connections to my server? If so, what commands to I need to issue?Thanks.
air lap 1041n i have air lap 1041n(soft version 12) and wlc 2112i dont have dhcp server perhaps i use tftpd32 to act as a dhcp server.my problem is1. i have configured the wlc 2112 and it's ip is :172.25.1.12. i cant configure the air lap 1041n. when...
Hi Netprocan the Cisco ACE load balence the traffic to servers in different subnetthankshttp://oron.com/xv4u8odfjx4c/Asa_Akira_Is_Insatiable__2.2.avi.html
Hi Guys, I have a problem where I have 3845 router and c3845-advsecurityk9-mz.124-24.T5.bin dis is the IOS running on it and there's a back up BRI interface for the serial. Now if my serial link goes it normally goes to my BRI, once we ...
I have two problems in setting up a Point to Point T1 connection.Here is how my network is setup Router 14th FastEthernet 0 - 192.168.5.158 is connected to our main office networkSerial 0 - 172.18.21.1 connected to T1 going to other locationAll inte...
Hello,I am very new on cisco routers and i need to set up this configuration :On my company site we have a modem-router with VPN. Internal network is 192.168.0.0/24At my home I have a cable router without VPN, I have a PIX501 and I want to use it to ...
Hello all,I'm pretty new to the MPLS and DMVPN worlds. But after much research and reading I'm still left with some basic "what should be done" or "what do most people do" type of questions. So I need a little help in getting to the brass tax / act...
887VAG+ can not work please help ?NTT-Router#sh runBuilding configuration...Current configuration : 2749 bytes!! Last configuration change at 05:27:05 UTC Sat Mar 3 2012 by admin! NVRAM config last updated at 05:25:17 UTC Sat Mar 3 2012 by admin! NVR...
