Routing

Hi,I have a Router 2801What conf should i make to access the webserver from the same LAN. !no ip dhcp use vrf connectedip dhcp excluded-address 192.168.1.1 192.168.1.63ip dhcp excluded-address 192.168.1.192 192.168.1.254!ip dhcp pool xxx   network 19...

Today on a site I have found the opinion:"Loopback interfaces are logical and maintained within software and  *NEVER* go down as long as the router is turned on and operating (unless  you "no" them). Anyone who uses a subinterface as a loopback  inte...

HelloDATA link Provider gives customer the choice of selecting MPLS Service with Layer 2 or Layer 3. Can someone help me to understand which is ideal and more benefited to end-customer. thanksST

Hi, my doubt is the next:Ii have the next topoly:     R5                      R6---------R7         \                    /          \                  /             R4            R2               \         /                  \     /                  ...

Hi,i have 1905  with isp reliance connection they have given 1)lan public ip 115.x.x.x/255.255.255.2482)wan public ip 115.x.x.x/255.255.255.252router i have 2 interfaces and i have 50 lan user and i have configured s0/0 for another branch,please let ...

From an EIGRP troubleshooting perspective, how can I find out the source of a specific route advertisement in the routing table?  With BGP, you can trace a route advertisement down to a specific BGP process ID. Provided a unique BGP process ID is con...

All,I have an ethernet circuit that we brought up this morning to test. We did a failover test with me shutting the interface down, and while this work it's not a real world test. BGP took a while to converge. (Timers are set to 7 and 21.) Basically,...

We have open a division in the UK and are using DSL as a back up to a T1-E1, so I was going to use a standard DSL Modem but thought the WiC-1ADSL-I-DG would be better. However I can seem to get the card up and running. Here is the interface config an...

Scenario: I have a vmserver w four virtual servers all in configured w in different subnets. What's the best way to configure a 3750-x switch to route traffic from the virtual servers to their vlans?Sent from Cisco Technical Support iPhone App

Dear All,is the ASR 1001 either with IDC OC3 or T3  support VPLS and what is the limitation, what is exactly support is it full functionality of VPLS?.Regards,

Hi,My company has a single 2811 WAN router with dual uplilnks to different ISPs right now. Recently we have had a major hardware failure issue that resulted in network outage. My manager reconsidered my recommendation of dual WAN routers but told me ...

Hello All.I have a problem.service-policy input Sawary isn't working for fake ip addreses.It's working for 77.87.16.98 but it's not working for network 10.12.0.0.We using "ip nat outside" rules on same interface where we using "service-policy input S...

                   Recent CCNA . Persuing for CCNP... One of the ccna book mentioned some IP address , like you can use those ips to test your topologiesI cant recall the book name.. Does anyone know. any help would be appriciated.