Routing

Looking at OER/PFR and I am trying to determine if the Controller can be on the DMZ along with the Border routers? So much of the drawings and topologies are so vague and non-descript.

Hello Experts,I have design question with following requirements & need your expert advice on it :- Current : 100+ sites connected using MPLS with static routes being redistributed into MP-iBGP on the PE's.My thinking to make it better & redundant :-...

Hi,We have Cisco 7609 Router and SIP module at slot.Now we are getting this error continue from yesterday asgivenbelow,%SPA_CHOC_DSX-3-HDLC_CTRL_ERRAlso find attached show logging, show version, show module command output.Regds,Ashutosh

I'm looking for some basics for configuring BGP. I do have a couple docs on BGP, but apparently I'm missing something.Here's my scenario:Two sites: site1 and site2Switches: Catalyst 3560sRouter: 2811 == 10.20.102.10VLANs: VLAN10 == 10.20.102.1 (prima...

The current link has for 4507R-E WS-X4648-GB-RJ45http://www.cisco.com/en/US/products/hw/prod_cat_visios.htmlWhere can I find Cisco Vision stencils for - 4507R - WS-X4548-GB-RJ45 and - WS-X4548-GB-RJ45V Appreciate any help in this.

Hi Everybody,im havin a problem with NAT at cisco router  7206VXR (NPE-G1) processor, Software (C7200-ADVENTERPRISEK9_SNA-M), Version 12.4(6)T11The configuration is as below:ip nat inside source list 2688 pool Office overloadACL 268810 deny ip 192.16...

We have the following port forwards set up on a Cisco 800s router. All internal IP addresses are NATd out to the IP on fa4 which is the external interface.  Traffic recieved on fa4 is forwarded to different servers depending on the type of traffic re...

When using the ASDM to manage an ASA 5520, I am using the packet tracer to simulate ip traffic from one inside ip address to another on the same subnet. The packet is dropped due to the Deny Any Any on the Inside interface.There is also a Permit Any ...

Hi All,I'm trying to setup Internet redundancy between two offices, so should one office lose internet connectivity, Internet connectivity will resume via the other office.The company has two office's which are connected via a wireless/microwave link...

i need a little help in connecting 3 sitessite A  10.x.x.x networkssite B 192.168.x.x  networkssite C 192.168.x.x networkswe also need to connect over the internetsite A has around 30 devices that will send data to a server at site Bsite B has a serv...

i have a cisco 1921 router and it has ge0/0 (LAN) and ge(0/1) WAN. ge 0/0 is well connected and i can ping it and the LED light is on but ge 0/1 has failed to come up.Ge0/1 is connected to an IDU and has a public IP address. The LED light also does n...