Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

hi , can any body give clear picture about BGP dampenening what i understand about this chapter - i mentioned below 1) BGP dampening  - help to prevent flap network propagate to neighbor dampening parameters  1) penatly - one time network flap (up ...

Hi,running a traceroute a noticed this:traceroute 10.191.21.1 source 10.191.11.1Type escape sequence to abort.Tracing the route to 10.191.21.1  1 10.191.111.14 24 msec    10.191.111.10 20 msec    10.191.111.14 8 msec  2 10.191.111.2 20 msec    10.191...

Hello,I've searched the forums but haven't found anything that explains the problem that I'm having.Goal: I'm trying to prioritize traffic to and from specific IPs (listed in an ACL) between offices by setting the dscp value to AF41Problem: On the b...

Hi,I am not able to connect a virtaul link to the backbone over a gns3. Please suggest if anything need to be changed. Every router are forming the adjacency but still not able to reach backbone Area0. Topology attached.R1interface Loopback0 ip addre...

I have a Cisco 2851 that is not booting correctly. It was working fine in one evironment and I removed it and reloaded it and went into rommon to get by the password and clear the config by setting config register to 0x2142. Thats all I did since it ...

I have what may seem like a basic question.  We have built some policers to apply to vlan SVIs on our 7613 so that we can rate limit input and output traffic.  We followed the Cisco formula and got this. policy-map vlan-shape-3meg  class class-defaul...

I'm new to cisco routers, i've very experienced with run of the mill home products like netgear etc. but i'm missing somethign here.I'm trying to setup a SRP-527W Router for a client. I have all the details in (Username, password, vci, vpi etc.). The...

mcsnoogins by Level 1
  • 2698 Views
  • 11 replies
  • 0 Helpful votes

Our network consists of 2 Internet routers one at head office and another at our DR site. The current setup is that the DR router has an interface cost of 30000 on the outgoing interface to the ISP to which we are running OSPF.The behaviour is all in...