Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Resolved! Cisco 3845 cannot detect HWIC-4B-S/T

Hi,I have just received a Cisco 3845 and I have installed 2 ISDN BRI cards HWIC-4B-S/T. The router has only these cards and a AIM VPN module installed.The router cannot detect the cards.I have placed an isdn BRI card  HWIC-S/T ( 1 port ) it detects i...

Resolved! Netflow problem help ?

Dear all,I have a Catalyst 4507-E with supervisor V-10GE. In this switch I have anable netflow service to manage flow on network. The functionality is embedded in the supervisor engine. I use open source "Flow Tool" for flow capture, in this tool I c...

NAT Fails

Hi, I am trying to NAT inside hosts to access the internet but it fails and gives this error message. Can somone please help what is going on.(NAT*: Can't create new inside entry - forced_punt_flags: 0)interface Dialer1 ip address X.X.X.X 255.255.255...

Resolved! Route-map with tracking

Dear Experts ,I Put an SLA as given below to track a route-map .The SLA stat showing up , but when I do show route-map its showing   [undefined] . Is there is anything missing ?ip sla 1 icmp-echo 192.168.111.5 source-ip 192.168.111.6 timeout 2000 fre...

Haris P by • Level 4
  • 4955 Views
  • 2 replies
  • 0 Helpful votes

IPBase to IPBasek9

Hi All,Can i upgrade my current ios from IP Base w/o Crypto (c3750-ipbase-mz.122-35.SE5.bin) to IP Base (k9) to support sshv2 without buying upgrade license?ThanksNino

TNZ EUBA Config

Hi,Any Kiwis out there have the configuration details for Cisco router running on the EUBA service from TNZ?  Particularly the Bridged Ethernet configuration.Thanks,Tim

Resolved! Failover from serial to Ethernet?

I have two sites connected via a Point to Point T1 link.  In each side of the point to point link I have two different subnets (i.e. 192.168.2.0 and 192.168.3.0).  I have a a full copy of each other on each side of the link (just in case it goes down...

Routing between 2 subnets and internet access issue

Hi,·         We have two networks 192.168.1.0 and 192.168.15.0·         The gateway (Sonicwall Firewall) IP is 192.168.1.1 (on this firewall we have terminated our internet connection)·         Currently both networks can access each other, but 192.1...

%ALIGN-3-TRACE: -Traceback=

HI,  I am Getting following error in Cisco 3700 Router with IOS 12.3 (26).We dont have any option to upgrade IOS since this is the only available IOS in the particular feature Set.What could be cause of this particular error... %ALIGN-3-TRACE: -Trace...

RV120W - Performance and speed, kill session

Hallo,I have problem about performance or speed with the RV120W VPN router. I have change the Hardware, (same with the same firmware) is the same problem. When I have a Remotedesktop session, he says, that the  connection break.I have change th hardw...

Resolved! Can't ping isp DNS or Internet

Hi For some reason I can't ping the dns or browse to the Internet.I have a cisco 851W I have DSL and setup to dhcp. When I do a show ip int 4 it shows a ip address picked up for my ISP. So  I know I can get a IP address but I can't ping the DNS wh...

Ports

HelloMy Setup isInternet------------------Internet_RTR-------------------ASA-----------------------Layer3Sw-------------------------------------User_Vlan                                                                                                 ...

View All
Review Cisco Networking for a $25 gift card