Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi All,I am having this error every few days and I have to reboot the router to resolve it. Any idea what might have caused it?Below is the error.000014: *Jan 30 02:02:14.531 GMT: %SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x6021...

noobieee7 by Level 1
  • 4506 Views
  • 5 replies
  • 0 Helpful votes

folksi have a site to site vpn with possible mtu issuesi have configured the ip tcp adjust-mss 1300 command on both the lan side closest to the AD servers and on the interface facing the wan on my local routerthe vpn doesn't start on the routers but ...

Network:6509 Core /w Sup 720Edge Switches - 3560's w/ IP Services imageProblem:FWSM doesn't support multicast routing in multiple context mode3560 doesn't support GRE TunnelsDescription:I have a multicast sources directly connected to a 6509. I've co...

b.gamble by Level 1
  • 3461 Views
  • 11 replies
  • 0 Helpful votes

Dear All,I am trying multicast video stream in my network but it is not working between Vlans. But its works fine in the same vlan. Using VLC for video straming. Router, switch and pcs are connected as given in the below link.http://www.cisco.com/en/...

Hi, I have ASA 5400 on two end US and INDIA. I am handling US ASA having internal range 10.32.130.0/24,10.32.129.0/24,10.30.100.0/24 & outside IP is 200.200.200.2. INDIA ASA internal range is 172.16.0.0/16 and Outside Ip 102.102.102.2. I have to make...

Hello,I have one ASA haivng own subnet is 192.16.1.0/24 & outside IP 100.100.100.100/24. I have created two VPN tunnel on that with Client-A and B.Partner A uses subnet 10.1.0.0/16. The problem is another Partner  B is also using the same subnet 10.1...

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of...

Hello there, Can I know what is this ACL meant? What is the "established" command for in this ACL?access-list 121 permit tcp host 192.168.1.1 host 172.2.1.1 establishedThank you

chris.lau by Level 1
  • 12140 Views
  • 3 replies
  • 0 Helpful votes

I'm stymied by hierachical QoS on the ASR 1004 platform and am hoping that someone can show me the light.Currently, I have a successful configuration on the ISR 3845 and 2821 platform where I have multiple GRE tunnels each with their own outgoing ser...

Hi,Following access list is used in BGP route filtering with "distribute-list Name_Of_Access_List  out" comand :ip access-list ex filterdeny ip host 10.10.1.0 host 255.255.255.240 ( /28 subnet )deny ip host 10.10.2.0 host 255.255.255.0  ( / 24 subnet...

Unanswered Topics
Review Cisco Networking for a $25 gift card