Routing

I guess i am in the correct forum. My cisco 3620 lab computer does not have an IOS that allows me to practive with SDM aleast I could not find the correct IOS. IOS (tm) 3600 Software (C3620-I-M), Version 12.2(29bDRAM configuration is 32 bits wide wit...

Hello, We use 2 PABX connected to each other via PRI. Config 2811(please see attached the file) is set between. We have attempted to send PRI via 2811 using Drop-and-Insert. Diagnostic commands do not show any error messages however PABX do not "see"...

I'll attach simple diagram... Scenario:From R2, 192.168.3.0/24 should use the FR link and backup PPP. Segments 192.168.1.0 and 192.168.2.0 will use PPP and backup FR.PPP uses static routes while FR is BGP routes.any idea how to achieve this or any r...

I have asked a few questions here regarding one of my ongoing network designs and have received some very helpful answers. I now have another question (or two). (BTW, I don't require EIGRP or OSPF on this network, RIP can handle it just fine)When u...

dear alli want make vpn connection for varius kind of peopleI want that a specific ip range for some people and a secondary IP range for other kind of peopleplease guide me about confgiurationregards

Hi there, I have reviewed everything possible and I still can't figure out:I shut down interface from Edge-1 to Primary ISP router. Then from Edge-1 I ping Primary router and I was expecting to see traffic flowing thru Edge-2. That does not work thou...

hellowill appreciate if someone can help to clarifythis is the set upsite a router-- isp routera---mpls cloud---isp router b---site bthe site a router lan interface does marking for citrix traffic as precedence 3.. isp router a does shaping for both ...

I'm a server guy but have taken over our networking as we are downsizing and trying to come up to speed as quickly as possible. I have a 6509 switch that routes traffic to the internet thru one provider. But have added a point to point t1(and added c...

Hi all,May I know the main difference between Cisco 7200 and 7600 boxes.From architecture perspective as well as features perspective.

Is there any rhyme or reason to how routes are listed with a simple 'show ip route'?I notice on the 2800 series routers, they appear random. On the 6500, they are clumped together with similar IPs, but not sorted. And on the 7600, they are actually...

I'm confused about static route adjustment interval. I have two 6509's running HSRP. There are networks that are statically routed through the HSRP interface. Each 6509 has static weights assigned to each route for failover.The question I have is...

we have dual sup engines.How do we plan for an IOS upgrade with minimum or no downtime?i would like to know the steps explained in detail

If I implement a Cisco 2600 series router with two T1 cards, am I able to bond the two T1 circuits together to double my total speed?

We have a mpls setup with 6 locations.I can telnet to all routers except for one. This setup has been in place for at least 5years. I was able to telnet to all of the routers until yesterday. There was no changes made to the infrastructure and now al...