Routing

Hi,I have downloaded Dynamips Simulator.I have 1.5GB RAM in laptop. Can I run this with this configuration ?

Which command is used on edge router to see the MPLS info.

Ref- Catalyst 3560 Switch Software Configuration Guide Pg: 12-21To reduce the risk of spanning-tree loops or storms, you can disable VLAN 1 on any individual VLAN trunk port by removing VLAN 1 from the allowed list. When you remove VLAN 1 from a tru...

I am using 2 static routes to the same destination network at my HEADOFFICE, one primary and one for backup. I want them to have the same preference so I have kept the default adminstrative distance. One Interface is high speed and the other is sligh...

My company ABC can establish VPN connection to company XYZ. Problem- cannot ping or access resources on company xyz network after establishing vpn connection.Facts- My company ABC LAN IP is 10.1.x.x & company XYZ LAN IP is 10.1.x.x.Question- what ca...

Could someone explain to me the difference between L2 Trunking vs L3 Trunking? This is mentioned in a Cisco document "Catalyst 3560 Switch Software Configurtion Guide" under Configuring VLANs Trunks. I appreciate the help in advance, sK

there is some way of my router (2811) receive a packet from a workstation in a interface A and send this packet to 4 servers in interface B?

Hello all,I have a problem with one of my frame relay circuit.Im not seeing any errors on the physical link , Im getting gud response when i ping the LAN ip ranges on both the side.But my question here is when I ping the Serial Ip's of this Frame rel...

When using 2 static routes to the same destination over 2 different interface eg 1 - primary and 1 for backup. Both routes have a default metric. Meaning that there is Static Load balancing.Does Load balancing mean that traffic will be halved or dist...

Can any body suggest me the command , if I want to modify Auto-Reference path cost in OSPF. My requirement is as-----10,000(Bandwidth in Mbps)-> 2(Cost)10(B)-> 2000(C)1.544(B)-> 12953(C)0.768(B)-> 26041(C)

Hello,Could you let me know the power provided in watt of the products below? My customer is searching for right product. ThanksPWR-1700-WW1=CVPN3000-PWR=AIR-PWR-SPLY1PWR-RPS2300PWR-2821-51-AC-IP=PWR-3825-AC-IP=PWR-2801-AC=PWR-AS535XM-ACRPS=PWR-ME375...

HIWhe have ospf processes on ours routers router ospf 1 log-adjacency-changes area 0 authentication message-digest network X.X.X.X X.X.X.X area 0 network Y.Y.Y.Y Y.Y.Y.Y area 0 distribute-list 80 inaccess-list 80 permit Z.Z.Z.Z Z.Z.Z.Zaccess-list 80 ...