Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Resolved! BGP MED

I'm trying to create a backup solution that uses a vpn tunnel as a backup to our WAN connection. We're running BGP, and basically I need to inject an alternative path into the WAN cloud to my networks via another site that will have a VPN tunnel to ...

I have two ISPs connected to my 2611XM. I use Cable connection as the primary connection and want to use DSL as the backup. I tried doing this using the track 123 rtr 1 reachability but couldn't get it working. I would appreciate if anyone could help...

Is the advertised distance the second lesser number when you use the sh ip eigrp topology command? The FD is stated but am not sure when I see a number like this (4115200/40640000). I think that 40640000 is the AD. Am I rightor not? Please Advise?

Hi guys,I have an issue with a remote site. it routes traffic to my primary site via a backup tunnel rather than the neighbor MPLS site. I cant see why this is happening. Please see the below config snipt and see what I'm doing wrong. My knowledge of...

rodonohu1 by Level 1
  • 1676 Views
  • 13 replies
  • 0 Helpful votes

I have a cisco router at my gateway.My internet bandwidth is terminated on it.I have 2 servers in my LAN which i want to access from outside. For this i have statically NATed them using a public IP at router.Now i also want to allow my internal host ...

Hi,I am planning to use eigrp for load balancing but we have a gre tunnel on one side of the link.Your inputs pls because my doubt is the tunnel goes down in this kind of scenario.Thanks,K0rg

Dears,I have two E1 connections connected to 3745 router ,the ouput of show interface command for one of these interfaces gives a high counters value for input errors and CRC and the counters keep increasing ,also the relaibility of this interface ha...

mohammady by Level 1
  • 664 Views
  • 4 replies
  • 0 Helpful votes

I have a 7604 as a WAN router. I need to use a service policy to mark dscp based on a subnet address using an ACL. In addition to this service policy, I also need to honor dscp markings from things like IP Phones. It appears that its improper to u...

jhancoc by Level 1
  • 476 Views
  • 3 replies
  • 0 Helpful votes

How can I determine which router to purchase based on port density and throughput ? I need to terminate two 45mbps ethernet connections into the router. A primary and 2ndary connection. The ethernet connections connect our office with two data cen...

eh2os by Level 1
  • 1224 Views
  • 7 replies
  • 0 Helpful votes

Resolved! 9 x pppoe dialers

Hi,I have a cisco 3845 and i want to run 9 dialers to the internet.I wan to have only one GigaEthernet link to the lan and the router will perform load balancing or sharing on the 9 dialers.What is the best way to do this and if there is a partial co...

We have a 2811 basic router that has a couple of Ethernet ports, an Aux port and a couple of USBs. Need to connect to a 4Mbps segment of a larger pipe. Do we need any further optional plugins ?

I'm currently working with a Cisco 3800 as a part of my network. Over the passed couple of days, the router has locked up, the activity light staying a solid green, instead of blinking. When I attempted to console in, I received this error:INTSTACK: ...