Resolved! NIM-2GE-CU-SFP speed
Hi,I was looking for the datasheet of NIM-2GE-CU-SFP but I couldn't find it. My concern is about the speed, I would like to know if this module can work with GLC-FE-100BX-D= Thank you.Have a nice day
Forum Posts
Resolved! NTP Update Error on Cisco 1841
SOLUTION: UPGRADE IOS TO LATESTProblem DescriptionI have a Cisco 1841 with IOS Version 15.1(4)M1.But it cant sync to my setting NTP server.Interestingly, there are 2 cisco devices under its subnet, a C2960 switch and a ASA 5510 working in transparent...
Resolved! Smart Licensing on 1100
Hello, I'm trying to register my ISR1100 device on smart account. I have generated idtoken and then inserted it to the router, but registration not happens. Registration:Status: REGISTERING - REGISTRATION IN PROGRESSExport-Controlled Functionalit...
Tired of shouting your opinions into the void? Tell us instead! Leave a review at TrustRadius.com and receive a $25 amazon gift card!
ha pair issue
Resolved! Multicast - Sparse / Sparse-Dense mode
Hello, I have MPLS L3 VPN. I have configured sparse mode on all P and PE routers and sparse-dense mode on all CE routers. On all routers I ran the command ip pim autorp listener and on one specific ip pim send-rp-announce loopback 0 scope 30ip pim se...
Resolved! EIGRP Troubleshooting
Hi Good day, May I request for advice on what went wrong on my laboratory. During the set-up process PC A, B and C can ping each other and works well I configured necessary interfaces, networks and loop back, use auto summarization for R1 and manua...
The router would first only boot onto rommon mode. This has been solved with these steps:Shut the router down.Remove the compact flash from the back of the router.Turn the router back on.When you see the Rommon1> prompt, enter the command of confreg ...
Hello, I have MPLS L3 vpn. I want to use pim sparse mode. I have configured one PE router to be RP and P router to be MA. On each PE I have MDT default in the vrf configuration (i have ip multicast routing vrf) and the other routers int the network a...
Not sure what happened here was working perfectly find for 2 hours than just no response I can ping and all the other Netflow are working router#show flow record TR2-R1-Internetflow record TR2-R1-Internet: Description: TR2-R1-Internet No. of...
Hello Dears,I am trying to enable EVPN multi-homing on cisco ios XR, but it doesn't allow using subinterfaces when I apply the ethernet segment under evpn section. ----------------evpninterface Bundle-Ether4.2001!!% Invalid argument: Subinterface n...
Hello Dears, I would like to post another question. I need to connect multiple routers in a single subnet as indicated by the vertical line. Should I connect them all 4x routers by a switch in Packet Tracer ? Does this make sense in the real world ?P...
Hi,If I am doing layer3 at the access layer and wireless ap's are also sharing the same switch, how the wireless roaming and all work Thanks
As per title. I would like to collect ALL message from a machine and dumping them inside a syslog file of 10 MB size that will overwrite it once it is reaching the size limit. Is that possible and how?
Resolved! Slowness issue to reach router from host
Hi , When pinging from host to router path 9k2 has slowness issue but path 9k1 doesn't have slowness but after sometime it get slowness issue as well , in short both path has slowness issue to reach router from host .What can be issue can anyone he...
