Routing

Hello,I am getting a lot of reassembled packets on a busy router. is there a way to see what those packets are. I need to know the source/destination IP at least. I do not want to impact the router's performance either, as it routes about 5000 pps. t...

Hi All,What is the meaning of V in v.35 and G in G.703 ?Regards,Jitesh

i have 2 switches 6509 and 6513i connect with two link one is Fiber and other one is Wirelesshow to make load balance using different media

Hi! Please consider following scene :XXXXXXXX#sh run int Serial0.19Building configuration...Current configuration:!interface Serial0.19 point-to-point description --- XXXXXXXXXXXXXXXXXX ip address XXXXXXXXXXXXXXX ip access-group 19 in <<<<< ----this...

i don't think it is necessity for sub-netting in ipv6 since there will be more no.of ip's available. is it true?

Hi All,i have a problem with isdn connection.i use it as the backup connection for leased line.When i make a test call to other end router using "isdn test call" the connection disconnect after a few seconds.i tried some solutions from TAC Case colle...

Hi,I'm learning to configure cisco pix firewallas and found following global NAT pool example in cisco page:global (outside) 1 200.100.100.110-200.100.100.150 netmask 255.255.255.0I'm wondering why cisco in examples netmask field is included besides ...

Ok I will first apologize for my ignorance since I am new to this. I am putting together some lab equipment for some hands on with regards to my ccna and future ccnp. I have purchased a cisco 2621 with 2 serial wic-1t cards with the standard aux and ...

I installed the an NM-2CE1T1-PRI into a 3845-MB router and it didn't pickup.Why?There's an existing NM-2CE1T1-PRI on the same router and it's working perfect. I tried installing it on slot 1. When I boot the router up I didn't see the module in the c...

I am using a cisco 1841 router and after I did an static translation on my router the lan users can no longer access the server. See below:ip nat inside source static tcp 10.1.4.15 80 12.xxx.xxx.xxx 80 extendableip nat inside source static tcp 10.1....

Hi,Can some one help me to solve my issue? I have 2 cisco switches how can i manage the bandwidth on those switches. Also is this possible to do on 2900 and 3524xl series or i have to buy any other switch on which i can manage the bandwidth. Please h...

Please explain ^150_[0-9]*$ in bgpregards:S

Hi, I have this config that is used for our Cisco routers at remote sites. They connect to a Cisco Concentrator. We use 877's, 878's and 1841's and use this attached config (apart from some changes to the internfaces). Any tweaks would be most wel...