Routing

I need to drive up my latency between a link to test an applications behavior. I have multiple routers I could use (1x3825 & 3x2801). I could use traffic shaping, but that doesn't let me input a latency delay in ms between packets... Any other tho...

Do I need just one cable or two? thank you.

Hi All, We just upgraded a 3640 Router Flash Memory from 8+8 MB to 16+16 MB. After the Upgrade we are trying to upload a Latest IOS(which is 21 MB) and we get the following error.----------------------------rommon 7 > xmodem -c c3640-jk9o3s-mz.123-24...

Am in a spot of bother with getting my SNMP management station (running Solarwinds) to poll a PIX501 firewall at a remote location connected via VPN.The remote PIX501 had its peer changed from the PIX535 to a VPN Concentrator that sits side-by-side w...

What are the usual issues when an interface (ethernet) is in an UP/DOWN status . DOWN = Protocol. Would it show this status if nothing was plugged in to the ethernet port..Thanks

I've been under the assumption that all QoS policies are only applied during periods of congestion. That is to say that my cbwfq is only applied during times of congestion. That makes sense to me, since tail dropping only occurs during congestion, ...

Hello everybody, I have a configuration problem with a cisco 800 series router. The client with the ip 192.168.99.100 can access the internte via http but not via https.I wonder why, since there is no exclusion of https in my opinion.Can someone prov...

Hello experts!how do i configure pppoe over a vpdn that is more than one hop away?thanks

I have a issue where im trying to install a vwic-1mft-g703 card in a 1841 router. The router doesnt seem to recognise the controller when I go into interface mode. But from what i can see you can fo into configuration and then to card type which is e...

Need some help here, I have one router with two BGP neighbors, both in same AS. Using a prefix-list, I need to distribute some of the routes learned from one neighbor onto another. All prefix-list, access-list ect command are in place. Of course, it'...

Hi,I need an urgent solution. We implemented an E1 link for a client with a Radio link for redundancy on our mpls vpn. However data traffic doesn't pass over the E1 link. However the Radio link supports both. My configurations have been check on both...