Routing

Hello,Here is my scenario.Business with two locations.LOCATION 1:*Cisco 2811*Firebox Watchguard X700*T1*Public IP on Cisco Ser*Privite Ip 172.28.159.1 on Cisco eth0/0*X700 also has a pub ip assigned to it as well as a priv ip*X700 is where I have my ...

Hi allI am configuring "Drop and Insert" in VWIC2-2MFT-T1/E1 on router 3845.My topo follos: PBX--R3845---Wan(voice and data)---R3845---PBX.After configuring, Voice and data is OK. I can make a phone call and ping successfully. But Fax and Modem analo...

if i have this wildcard mask:0.0.0.15does it mean that the "do-care" bits are the last 15 bits? so in binary its:10000000.00000000?and how i interpret this wildcard mask:0.0.15.255?

I know I've come across this before, but can't remember solution/answer.I am unable to ping a remote server interface from our hub router unless I use extended ping.I can ping from my PC to the server, just not directly from the router (unless using ...

hi,i am hosting an application server at HO to which clients connect using the client application, using 2 ports.(8090,8092). We were using a DSL connection and eveyrthing was good.Now we bought an E1, terminated it on 2811 using e1 controler card.I ...

I have a lab setup with a router, layer three 3550 switch and a PIX firewall.The router and the firewall are plugged into the switch in seperate VLANs and are using the switch as their default gateway.All three devices are configured in the same OSPF...

Friends,I have a cisco 2610 router, IOS version 11.3(8)T1. Though i have logging configured, the router does not show any log messages and i am not sure what the problem is. Plz find below the config that i have.logging buffered 16384 debuggingloggin...

Hi,I have recently switched to a Cisco 877. I have an ADSL 4-mbit service. Things were working fine for about 6 weeks but now bandwidth is awfully low.When I do show dsl int atm 0 it shows: DS Channel1 DS Channel0 US Channel1...

i have load balanced between etherdrop & multilink in ospf ...Applied same QOS on both link but i have observed that on multilink packets are being droped in QOS & same on etherdrop is fine without any drop .. please help me........

Here is my network configuration: 10.10.10.0/24 -(Firewall)--- R1 -- (static)ISP ---- R2 --- (OSPF)---R3----(OSPF)--- HQ ----- - R1 connects to R2 through an ISP with a default route to R2 - at R2 + Subnet 10.10.10.0/24 is redistributed into OSPF + S...

What problem does it indicate when the input packets are ignored? I know that indicates the hardware runs low on internal buffers. Does it indicate a hardware issue? How do I check sanity of the hardware (it's a CHOC12).#show inter Se7/0/0.6/25:1Seri...

I have the following setup on a router to a DR site and I would like to simulate this in a lab environent.The connection is a DS3 and is frame relay.Is there any way to simulate this on a regular point-to-point T1 connection with a crossover cable fr...