Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Resolved! How to enable a new 1811 router to work with SDM

Hi,Let me start by saying that I am a newbie and I am trying to learn as fast as I can. I have searched if someone has posted similar questions in the past however I couldn't find anything that is similar.I just got the 1811 router and I am trying to...

ATOM Cisco 7206VXR (NPE-G2)

I try to configure ATOM in two 7206VXR (NPE-G2) routers as the following-first routerinterface ATM2/0.100 point-to-point no snmp trap link-status pvc 0/1234 l2transport xconnect 10.1.1.1 50 encapsulation mpls-second routerinterface ATM2/0.100 point-...

Cisco PIX 506e with multiple internal networks

My configuration is not very complex, yet I'm not achieving the results I want.Our 506e connects on the outside to a T1. On the inside interface, it plugs directly into a switch. Also plugged into the switch is another router which connects to anot...

Cisco Mobile IP

Hi,Can anybody tell me what is mobile ip and how I can have it integrated in my Local Area network. The scenario is like this:A 2811 router connected to a 4503 (4503 have a data and voice vlan). Subinterfaces are made on 2811 and 2811 is acting as a ...

IPs address problem

Few of the IPs are unable to access external resources where as it is working fine on LAN and when trying to access any of the external Server it is getting stop at the gateway. The network is flat there is no VLans configure neither Access list is t...

Resolved! Is my Cisco 1811 router defective?

Hi,I just bought a used Cisco 1811. I have read the Cisco installation guide and connected one straight cable from my FE1 to my DSL model and another straight cable from Port number 2 of the switch to the LAN port of my computer. (I have also tried t...

Resolved! SHOW CONTROLLERS COMMAND

Hello,When I run a show controllers command I get the following....HD unit 0, idb = 0x29A82C, driver structure at 0x2A1DF0buffer size 1524 HD unit 0, V.35 DCE cable, clockrate 64000ANDHD unit 1, idb = 0x2A7680, driver structure at 0x2AEC40buffer siz...

Resolved! New BSCI equipment requirements

Hi All,I am looking at the suggested lab setup and wondering how important it really is to have 2811 routers?Is there any major disadvantage to say using 2600 series instead? My setup would be the same topology etc - just different model router. What...

static routing

Hi,I have two router( A and B) and these two rotuers are connected with two separate E1.My data will pass from B's ehternet interface to another router's interface( C). The address of C's ethernet is x.x.x.193/224 and B's ehternet interface's Ip is...

bikash_bd by • Level 1
  • 368 Views
  • 1 replies
  • 0 Helpful votes

Redistributing EIGRP to BGP

hi guys,How can i limit my redistribution from eigrp to BGP to only /24 networks? when i redistribute eigrp routes to bgp, /32 and /30 networks are also advertise unto bgp. i don't want this to happen, just want only /24 to be advertise by bgp. Doing...

View All
Review Cisco Networking for a $25 gift card