Routing

Dear Colleagues,how could I make a route-map to respect "continue" clause? I have already tried many IOS versions, as well as different route-map configurations. Please regard the following sample setup.two routers:AS999 (c7200-ik9o3s-mz.124-8a.bin)A...

Hi, our users connect to our HQ PIX 515 using VPN client 3.6.3, authenticate to domain via IAS, and are assigned IP address eg 1.1.1.10 from pool, also assigned dns server address 1.1.1.5. Remote user can connect to all servers in HQ, which are all I...

Hi,We use a class B network address with a /25 Mask. We have three sites connected via E3 and 100Mbps Circuits. My question is this:We have a VPN Tunnel that acts as backup when the primary links in one site fails. I have 12 floating static routes...

Hi allI have a 1800 Router - Connected to a serial WAN Link - this is connected via upstream provider though mpls cloud and is not directly connect to my network.The router also has a DSL backup direct to our network.If any link on the wan goes down ...

Hi.I'am using NAT.I'd like to install server inside. Traffic with specific port number from outside have to be connected to inside server.I opened this ports on access-list. but it's not established.I think this traffic can't find inside server.What ...

how much DRAM & Flash required to configure 6 ISP lines (with 6MBPS). Please suggest me.

Hi, I was assigned for a small scale project last week and the main purpose is to interlink three sites together using fiber connection. Here's the detailsi. Main building (Cisco 3560 with SFP) to Site_A (3Com Superstack 3300 100Mbps Fiber)ii. Main b...

Hi, I have 2 routers with a pix in the middle, the pix has an ip of 192.168.1.7 there is then a VPN connection to a remote site with the address range 192.168.254.0 I have added the route as shown below for the 192.168.254.0 network and I can ping Se...

Hi, Messrs!I would like your help! A connection router-to-router with tunnel doesn't work with IOS C3745-ADVENTERPRISEK9-M, Version 12.3(14)T7 and C3745-JK9S-M, Version 12.3 (6a). What could be wrong?So many differences betwen versions?What could I d...

Hi,i want to understand what is the usage of bridging in comparision of ip routing and switching..in many config i see that the router has bridge config.... can somebody send me links for sample cases/config..Thx,G

what does 'neighbor a.b.c.d soft-reconfiguration inbound' do (when configuring BGP) ? i've configured a router using this command, but honestly, don't know what it does ... hehe.

Dear All,Can I get full 2.048 Mbps on 7206-VXR with this module for channelized E1. This is what I get from Cisco site."The RJ-48c ports are software-configurable to support T1 or E1 (120 Ohm) interfaces. In T1 mode, each port can support up to 23B-...