Routing

we have a configured ppp multilink interfaces between pairs of Cisco 7609 and Cisco 3640a routers and put 15 E1 lines in each of them. Now the problem is whenever any one of the E1 line generates CRC errors it generates delays on the multilink hence ...

Hello sir,My customer's router is AP10KREDGE. My customer did engine switchover work. But after that. there are some error message:"%REDUNDANCY-3-SWITCHOVER: RP switchover (PEER_WATCHDOG_INTERRUPT)%REDUNDANCY-5-PEER_MONITOR_EVENT: Standby received a ...

Hi Netpro's,How can we allow/deny traffic based on mac addresses either on Firewall or a Router. Waiting for your valuable responses. Thanks.-Faiz

Hi All,I have a task to config ipsla to find out the performance of all our notworks accross the globe but i dont have enough knowledge in ipsla. can any one let me know how to conig this and some documents on this topic. Thanks & RegardsGopal

Is there a quick way to reset the RIP process on a 4500 series switch with out bringing it down?

Can anyone advise please. ISP has assigned a single static ip address of xxx.xxx.xxx.xxx . They have now assigned 6 more static addresses but on another subnet. The router is configured for rfc 1483 bridging with the single static ip assigned to both...

Hello All:I realize that this may be off topic but the only reason I have posted it here is because if there is an answer to be found, this is the place. I know of no other newsgroups that host the technical expertise that this one does. I'm having a...

Hi All,I have added a new network that my vpn users are allowed access to. I see it in the config and I also added the routing in the asa as well but still cannot get to the new network. is there something I must clear before this is allowed?TIA,R

I am newbie to Layer3 Switching, Please some one tell me the advantage / uses of L3 switches over router. Also please tell me whether can I use the L3 switch as router for WAN connectity.Thanks in Advance.

Hi All,I'm after some advice on a network design for a small ISP please. Currently this ISP has one POP in location1 and they are looking to expand into location2. Transit bandwidth is cheaper in location2 so it would be advantageous to connect both...

I?m in the process of designing a secondary site-site VPN/GRE for my company so obviously if our primary Internet connection goes down (DS3), our secondary Internet connection (4xT1) would take over until the primary connection is restored. I?m using...

I have 8 T-1s coming into a location that are configured for multilink frame relay on a public router (outside of the firewall). I need to configure frame relay switching to a router that will be internal to the firewall. I've considered HSSI (PA-H f...

Hi what are the configurations need to do on a router for 2mbps leased line connection. i have wan ip for serial and link has been connected to serial port of router through csu/dsu(v.35). lan ip pool also given by isp which i want to know how to use...

I need to create an access-group where they can only talk to each other and no one else can communicate with it. And before I implemented, I need to make sure it works otherwise I would have to drive a long way to remove the access-list. Also group s...