Routing

CAn you please tell me the usage of the following commands. And also suggest if removing this might hamper the router functionality in any way, as my ROuter has been hanging frequently.ip flow-export source Ethernet0/0 ip flow-export version 5 ip flo...

I have a GSR running redundant GRP-B= with 256DRAM. We need to upgrade the GRPs to 512MB memory. My plan is to remove the standby GRP first then install the additional memory cards then insert it back. At this point, can I just remove the active GRP ...

Hi, can I know what IOS command can be used to check the leased-line speed?

Hi there,The ip bgp-community new-format is documented as a local display command to change the 32-bit format in AA:NN format (4 bytes), in addition the documentation indicates this command has no effect in the community exchange; however, I have exp...

Hi Guys,Normally when I upgrade the IOS image of my Cisco Router, I boot it in ROMMON mode, and then do the upgrade activity.I have a special requirement for which, I have to remotely upgrade the IOS without console access to a Cisco box. Flash capct...

I am going to buy a 3640 and then purchase a 2fe2w module. What is the difference between this and version 2? I was told that you cannot advance to higher IOS with the non v2. Is there a link that shows the differences in IOS (12.3 and higher) A...

We are in the process of setting up a WAN environ using MPLS from two different providers; sites are located in the US & UK using either T1/E1 connections for small offices and T3/E3 for the two large offices. Each MPLS link has a dedicated router (2...

Hello,We are converting service providers and a new local company has installed a PRI line to replace our existing PRI from our old provider. We are trying to test the new PRI line before we disconnect the old one, but the new PRI will not carry dat...

I'm looking to implement qos for our web applications. I would like to give client pc's priority access to our web server. The server resides at our central office and the clients reside in an off site location connected via a frame relay circuit.On ...

I am currently testing IEEE1588 and would like to introduce packet delay. The intent is to see how 1588 responds when the switch fabric starts getting consumed. I'm not certain what the capability of the fabric is but know its much more than the traf...

Hi,Having no clue about the track,I really appreciate if someone can help.A router support it by our team is running on ISDN however this router does not have any isdn activiye.g sh isdn sta is not accepted moreover the sh track command show then the...

I am able to remote telnet to a 804 ISDN router provided I telnet from a workstation that is also in the same ISP domain as the router. I'm using NoIP DSN for translating the 192.x.x.x IP address of the router to a host name. When outside my ISP d...

hi all,In a few months we will be deploying a new design with very centralized servers. in our remote sites they will have domain controller to reach for dhcp, but in the even that it should die, i would like to able to assign an ip over the wan from...

Greetings,I have 2 circuits both with different start and end points that go down every 2hrs and 15 minutes, and then come back up for exactly 2 hours and 15 minutes. Then go back down. Any ideas?