Hi, I'm having error message while adding the vBond controller from the browser, as "failed to add device /failed to get SSH session"
Forum Posts
Hi GuysvBond sits in DMZ with NAT 1:1vSmart , vManage lives in inside zone and talks to vBond in DMZ using Hairpinning Question========when the cEdge Talks to vBond over INTERNET and get Authenticate then how the vBond hands the IPs of vSmart , vMana...
I'm interested what happens when some of ipsec ports were blocked?from design guide we have 20 ports for ipsec tunnel, if I will block the active port and restart transport interface the wan edge changes port or not?
Hello all, Has anyone done any cost comparison of various SD-WAN solutions with respect to pricing & cost? If yes, please share it. Would like to understand how the SD-WAN costs differ for each product/vendor solution? Are there any
I understand that vBond is facilitating the Tunnel connection between vManage and cEdge.To establish a tunnel connection, both vManage and cEdge need to know each other's Global IP, and vBond provides this information.In the architecture in the attac...
Hello all,I have a Viptela Vedge 1000. When I select the device on Vmanage , I can see my default route in the running config; however, when I SSH directly to the device, I do not see the default route in the running config. The default route is pres...
We are setting up a SDWAN with the controllers on prem. We would like to put the vSmart and vManage behind a NAT (not 1:1) using a ISP wan connection (not mpls). The vBond will be placed outside the NAT with a public IP. I know the vBond can act as a...
Here is the scenario.I have multiple private WAN connections providers that do not allow routing our own IP blocks. So the vBond is published (1:1 nat) to these private networks. VBond is also published to internet (1:1 nat). The vManage and vSmart c...
Hi,We have a couple of sites with sd-wan and we need that they stay connected to the corporate network much time as possible in case they lost connectivity with controllers.We have changed the keygen-interval to 2:00:00:00 and the OMP gracefull rest...
I'm having these logs constantly on my router and it's bringing down my network constantly, it's inaccessible for a few seconds then it goes back to communicating alone, has anyone ever gotten an error similar to this *Aug 24 19:26:04.986: %IOSXE-6-P...
Hi All,We are using Viptela 20.6.x. I am currently monitoring via SNMP all our vEdges.I would like to track L7 trackers (new feature 20.6) with SNMP traps. However, I can't find the 20.6 MIBS:https://github.com/cisco/cisco-mibs/tree/main/viptela-mibs...
Ok, so I've got a licensed CML product with Cat8000v nodes and I want to use them as SDWAN edge routers. I go through the initial stages of onboarding and then find I need the Chassis number and Token of a 8000v in a device list in vManage, which I d...
My guestshell would not enable on Linux what’s the cause
Hi Team,I need some information about the behaviour of topology on which we are going to upgrade . Current Scenario ( Fig-1)We are on the legacy network and using Nexus as an Edge device. Our WAN links are terminated on the nexus. All the traffic fro...
Dear Experts,While doing redistribution from OMP to OSPF, cant we set the type E1 and associated values?
