I have been playing with sdwan in eve-ng with the topology below. I already bring up the tunnels and can see both sites up to vpn0 from each other. still getting use to and practicing with templates but i really having difficulties in how to send t...
Hi there,Is there a document which outlines what inbound and outbound ports are required for Cisco Viptela controllers?The intent is for all the remote sd-wan branches to use public internet (without MPLS) to connect to Viptela Controller on public C...
Hello, I have a doubt about the NAT DIA tracker, if i only configure the dia tracker without the fallback it will monitor the local dia, if internet dia 1 fail nat dia tracker will reroute the traffic to the second internet dia 2? The natfallback is ...
Hello experts, I have configured VPN interface ethernet template with Dynamic IP on interface GigabitEthernet2 interface which belongs to VPN 10. When I apply it to CSR1000v (AWS EC2 or ESXi VM) i get an error: [28-Sep-2022 21:28:11 EEST] Configuring...
We are doing a large SD-WAN deployment and we have created a device access policy only allowing SSH access from certain devices to the vty lines for all SD-WAN routers, all good. Question is how can this be achieved on vmanage/smart/bond. There looks...
what would happen if vsmart goes down as vsmart has OMP peering with Vedges so would Vedge lose its connectivity due to this with other Vedges?
Hi, I have a few vEdges in the warehouse that i would like to update before sending them to the remote site, i would like to download the OS image in a USB flash drive and connect it via the USB port in each vEdge, is there a guide for doing this?. I...
I am unable to find another hdc 100GB in this list, it's showing only one hdc that is 3GB only ...am using this controller in eve-ng , please let me know what could be the issue admin connected from 127.0.0.1 using console on vmanageAvailable storag...
Everyone Would like to understand about the below with respect to OMP & OSPFI am using OSPF as my service side routing protocol & all my vEdge routers are in OSPF Area 0.My understanding is that vEdge advertises the routes it learnt from OSPF via OMP...
Hi,I´m building a Viptela lab and managed to deploy all the controllers (vManage, vSmart and vBond), added them to the overlay network and installed valid certificates in them.However, after importing a .viptela file with several authorized vEdge clo...
HI ExpertsSDWAN:20.6.3Cloud: AzureI want to install Cat8kv on Azure by Cloud Onramp for IaaS, i found there are some questions.Q1: there is only 17.4.1a version can be choosen if i use Cloud onramp for IaaS ，Although I have turned on Programmatic De...
Hi I have a ASR1002-HX and I am trying to load SD-WAN image on it. I am following the documentation. The images I've tried are asr1002x-ucmk9.16.12.1d.SPA.bin and asr1002x-ucmk9.16.10.3a.SPA.bin and both go into a boot loop. At the moment I am tryin...
Hi Experts,I have a question I want to confirm. I did Cloud OnRamp for Multicloud. When I was mapping vNETs, I found that only the vNETs where the vWAN vHub is located can be mapped (for example, they are all in Asia, but the US vNETs cannot be mappe...
I am looking for SDWAN LAB but not able to find the link in dcloud. Can anyone share ?
Been banging my head against the wall this week. I have reset and redeployed a vedge about 10 times with same result. Running SDWAN software 20.3.2 on all controllers and vEdges. Within vManage I always get an error of "Certificate Installation Faile...
