Question Hello Gents,Kindly, I have an IOS-XR 9K device, which the port HundredGigE0/3/0/0 is not becoming UP and remains down.This is the IF-CONFIG: interface HundredGigE0/3/0/0cdpmtu 9200lldpenable!transceiver permit pid allI tried the "transceive...
The Problem As with any complex system, IOS-XR routers will encounter failures, whether they’re limited to a single component, or they affect modules across the entire device. In most cases, there is a standard path to debug the issue: Log into the ...
IntroductionFile System overviewSummary steps for using turbobootSteps to TurbobootClear the ROM Monitor environmental variables on all RSPsClear disk mirroring variablesDisable the CPU watchdogDefine the network and IP settings on the mgmt interface...
Step by step procedure below. to Install Cisco ESXi 6.5.0 on UCS 1. Download the ISO by navigating to www.vmware.com > My VMware > Product & Downloads > All Downloads > VMware vSphere > Custom ISOs > expand the OEM Customized Installer CDs option a...
Hi All, In scaled EVPN deployments it can be wise to name ESI that way to represent the site/physical port/etc it is attached to. Thus on some remote location you can easily verify where particular route/MAC is coming from. Similar to phone numbers, ...
* => TENTATIVE ** DWDM-SFP10G-C : Both JDSU and Oclaro are supported [toc:faq] 40G LineCards A9K-40GE-L, A9K-40GE-B, A9K-40GE-E A9K-4T-L, A9K-4T-B, A9K-4T-E A9K-40GE-SE, A9K-40GE-TR A9K-2T20GE-L, A9K-2T20GE-B, A9K-2T20GE-E A9K- 40GE-L A9K- 40G...
Introduction ZTP or Zero Touch Provisioning was introduced to reduce the human interaction in the provision of XR devices. ZTP helps in auto provisioning after the software installation of the router using iPXE. This document is intended for first t...
The interfaces of P and PE routers are enabled for frame mode MPLS with the mpls ip interface subcommand and all P and PE routers use a common IGP (EIGRP with AS 200): P#show mpls ldp neighbor Peer LDP Ident: 1.1.1.1:0; Local LDP Ident 3.3.3.3...
MPLS has been the leader in providing VPN service in the past days with the association of LDP for label distribution to achieve the necessary operation for traffic forwarding (not to forget that BGP is used in some cases for label assignment, but th...
Introduction ASR9K XR and ASR903 (IOSXE) ISIS behaviour Problem ASR9K preferring ISIS L2 for prefix (Lo0) of peer ASR903 (IOS-XE) due to which RAN instance interface is getting preferred Solution IOS XR & IOSXE behaviour IOSXE & IOSXE behaviour...
The Problem: A Service Provider’s customer would like to acquire service that would provide them with a certain bandwidth guarantee, for e.g to run a backup service.The Solution: Bandwidth on Demand engine in WAE will compute a path that will guarant...
The Problem: Identifying the right amount to augment capacity to meet traffic demand is a guesswork at best. In addition, circuit activation across the different layers would be an arduous process.The Solution: Orchestrated circuit activation based o...
The Problem: Network state changes continuously and operators are having problem tracking and reacting to rapid network changes that often lead to congestions.The Solution: With Crosswork, WAE, SR-PCE and Segment Routing, closed loop network state t...
Introduction Telemetry configuration & troubleshooting steps Below is the list of telemetry sensors which can be used for system health monitoring. It includes ASR9K & NCS5500 platform Configuration Sample telemetry model-driven destinatio...
The Cisco Document Team has posted an article. This document describes the procedure to troubleshoot incomplete diagnostics.sh script execution in Cisco Policy Suite (CPS). Know of something that needs documenting? Share a new ...
mkhalil10
Meddane
