Switches - Small Business

Picked up an 8 port SF302 on the fly to replace a 2960 that has failed. Attempting to config for use with DATA and VOICE vlans. Device port G1 is connected to 0/1 on a 2911, which has 2 sub-interfaces- 1 each for voice and data. Cannot get switch to ...

I have a SRW248G4P switch that isn't responding to either the console or webview.  When I power on the power lite stays yellow.  Is it completing the bootup?Anyone have experience with this symptom and perhaps a solution?Thanks in advance,Robert Jone...

In our scenario setup is following:Trunk from 3500 going into SF300-8 #1 QNQTrunk from SF300-8 #1 going into trunk SF300-8 #2QNQ from SF300-08#2 going into Trunk SF300-24All Vlans from Network 1 seem to be communicating properly between the 3550 and ...

I get a empty blue window when I try to open "port to VLAN"We have upgraded the software but it dosn't help.

Hi,I need to know how to configure each port in switch SG300-10 to vlans, i need to configure one port "trunk" with catalyst switch and assign 4 ports to different vlans. any solution?!Thanks

I have a question on how to setup an ACL configuration on the SLM2024.  I originally got this switch to just be able to monitor network ups/downs on the ports.  and this has worked great in diagnosing the problems I was having originally.  Now howev...

Hallo,I am using the CISCO SG300-28 switches with freeRADIUS, dynamic VLAN, Guest VLAN and MAC based authentication without any problems.I have got a question to the fuction "re-authentication" in "SECURITY -> Port Authentication". The default time i...

Hi,I have an SG300-20 here for testing (firmware: 1.1.2.0, boot version: 1.0.0.4, language version: 1.1.1.6 English). Everything seems to work on it, except, that if I choose Radius authentication by mac address only, then the switch does not honor t...

Hello,            I have SG300-24 in L2-Mode uplinked to Sonic FW. The only settings that seemed to work  is100Mb Full-duplex on both sides. If there is any other setting like auto-auto or 1000Mbits on both sides link goes down.I also set portfast en...

Hi,I would like to edit .cfg configuration file of Cisco SLM2008. However, I can't read the file because I don't have a good editor(.cfg is a binary file).Someone can help me?Thanks!

Hi folks!The embedded telnet client is OK but what about a ssh client? It could be a very useful feature for debugging remote servers or network appliances in a secure fashion.I understand the overhead concerning the image size and CPU usage, but it ...

Hello,I am using a couple cisco sg300 28P switches along with a sonciwall firewall/router. The sonicwall was already in place and working so they didnt want to replace it. I understand how to configure the vlan on the sonicwall, but could use some he...

Dear All,I have a couple of SF300-24 switches. When I made needed configurations using CLI or GUI and then saved all configurations. The problem is that switches do not save configurations after reboot. Please assist.Thank you in advance

Hello,We mount all our new network structure with CISCO ESW 500 Series. We nedd an optical Switch but not a Catalyst because we don't have the competences to programm all route and VLAN rules.My question is does exist an Optical Switch that use the s...

Hello,I have a SGE2010 and have one static LAG going to each of my (two) ESX servers.  From my testing it seems that the LAG speed is maxing out of 1Gbps.  I am unable to get anything faster than that.  I cannot find the load-balancing algorithm that...