Switches - Small Business

I need to create a LAG consisting of 4 ports on my SG 300-20.When I go to create the ports via Port Management - Link Aggregation - LAG Management - LAG1 - Edit and move ports 5,6,13,14 over as LAG Members - Click apply I get Port gi5 belongs to a VL...

I use PuTTY to SSH into Cisco switches regularly. Today I ran into the message 'incoming packet was garbled on decryption'. I logged into the switch via HTTP and saw the uptime was 115 days. After seeing I could PuTTY into the SG-300-28P right above ...

I have installed OpenFlow Plug-in on Cisco WS-C3850-24T successfully. When I activated it, it comes with:  *Apr 6 04:21:55.208: %ONEP_BASE-6-SS_ENABLED: ONEP: Service set Base was enabled by Default*Apr 6 04:24:05.398: %VMAN-3-START_FAILED: 1 vman: V...

Hello all.  I just received a new Cisco SG300-10 and am configuring it in Layer 3 mode.  I am trying to setup multiple routed VLANs going back to a FiOS Actiontec router.  My configuration is as follows.Fios Router: 192.168.1.1Assigning DHCP 192.168....

Hi, After updating the firmware from 1.3.7 to 1.4.86, the switch is not recognizing any Ethernet connection to it. Also the reset button is not working after the upgrade. Any ideas would be useful.   Kind regards.

Dear colleagues,   We have an issue with Cisco SF220-48P switches. After some time when switch is powered On some distortion appear for approximate 1 minute when link state is blinking for interfaces and after it, there is some fenomen thing : for ex...

Good afternoon.  This is probably an easy fix, so here it goes.  I have a requirement to have separate VLANS in my ESXi 6.5 environment that have to communicate with separate PCs on the outside.  I have only 1 NIC on the server so I've created 3 VLAN...

I have now had two Cisco SG-series switches (partially) fail with the same symptoms.   The left-hand side of the ports dont work.   When the switch boots, they flash on and off as per the normal boot process, but once booting is finished, they don't ...

Please tell me the difference between 200 and 250 series eg. features or ways to configuration. Anyway I'm aware that some of 200 series has been list on EOL and replaced with 250.

Hello,   I have a few Cisco SG300-28PP switches at a customer location.  We are using Auvik to monitor these systems and just enabled the CLI functionality.  Upon doing so, several of the switches started rebooting.   On Auvik's website I found this ...

I bought a new SG300-10MPP to drive some Cisco WAP371 wireless units using POE+.  I setup the SG300-10MPP and connected it to my SG300-28 layer 3 switch.  When I tried to create a VLAN 2 access port the window blimps out using Microsoft Windows 10 an...

TL:DR; How do you enable PortFast on a SG250-26HP?   Full story: I have just installed a DoorBird doorbell, that has a IP camera, and have some problems. It gets power, but cannot access my LAN. Looking into the logs, it connects (see later in mail) ...

I have a problem with a fan.  The fan is operational, but I get a ton of log entries and the system LED is blinking.  The firmware is 1.4.8.6, and the boot is 1.3.5.06 Any ideas what's going on?   21474834732018-Mar-16 00:19:44Alert%Environment-A-FAN...