Switches - Small Business

Can anyone confirm if this bug is also related to SG series? Because I have a stack of two SG500 and some GS105PE. All GS105PE does sometimes recognize PoE+ and sometimes not. At almost every reconnect I get a different result. I can't think of the c...

I can't upgrade my SG300-52 (VID-V02) to version 1.4.8.6. Current firmware/boot is 1.4.7.6/1.3.5.06. I was able to successfully transfer the 1.4.8.6 firmware image to the device and checking on the Firmware Version (Non-active) in the System Summary ...

We are using the sg300-20 switchA each static ip address should be assigned to each port . Can it be set up? ex. port 1 is static ip address 10.0.0.1 10.0.0.1 is set on the device even if other devices are connected.

Dear Friends,   I need your help,   We needs to extend vlan from asa to switch.   ASA --->eth 0/2.108 & 0/2.109 ------->  Connected with SW2 ====> vlan 108 , 109 available (L3 available in Firewall) ASA --->eth 0/3.101 & 0/3.102 ------->  Connected w...

SG350XG-2F10-K9-EU - 10 x 10GE copper + 2 x 10GE SFP+Hi, We have two HBA with SFP+ DAC (Mellanox ConnectX-3) we would like to connect to SG350XG, at the same time of other RJ45 10GE ports. Are the SG350XG's two SFP+ stack ports usable as standard 10G...

When i add more then 24 ports to a vlan the switch (sg220-50) becomes unresponsive. like: interface range gi1-46SwitchCC870B(config-if-range)#switchport mode accessSwitchCC870B(config-if-range)#switchport access vlan 3   Adding ports 1 at the time th...

I have a SF300 series switch.  I need to enable DHCP.  When I attempt to enable it, I get an error message to disconnect all DHCP clients.  How do I do that??????

hi,   we have 3 cisco SG500-52 switches with 5 vlans.   one vlan is only for sonos speakers. a few days ago 5 sonos speakers appeared in the wrong vlan, strangely the ports on the cisco switch had suddenly different vlan-settings - I didn't changed a...

I am using a CAT-5E cable to the GE port on each switch, Port 9 and Port 25 respectively.  I am using a standard Ethernet cable.  When I do this I can't see any of the devices on the other switch.  If I just connect one of the other ports on both swi...

Hi I would like to find out if anyone has managed to setup the Cisco SG220-50 switch to import public keys for SSH access.  The web interface for the latest firmware (1.1.4.1) does not seem to have that feature. When I ssh to the switch, I get prompt...

I have cisco SG500X-24. I setp up on it port mirroring. Firts options destination port GE1/1/13 source port GE 1/1/7 TYPE Tx and RX. Open wiredshark and see only TX.  Second options destination port GE1/1/13 source port VLAN1. Open wiredshard and i s...