Switches - Small Business

Hola, I've 3 switch units of the same model, 2 of them presents the same issue. The PoE devices I plugged in them aren't powered. Checking the switches via CLI I could see this: ------------------------------------------------------------------------...

Hello Cisco  Community, If I have the following part number SRW2008-K9-EU Can you tell me if we can swap a power cord out of this and make these –NA versions it looks like the unit uses a power cube adapter? Your help is much appreciated, Reg...

i am from india and trying to buy a product of 8 port POE, people are quoting two models with huge cost difference. i would like to understand the difference and if there is no difference i would like to go with low priced one.the first model with hi...

Hi, I have two SG500XG-8F8T switches in stack up and running into my data center. Now I have to add new 10 Gbit ports because both switches are full. I know that SG500XG-8F8T is out of sale, so what kind of switch I can add to the stack to have 16 mo...

Hi, On a IE 2000-8TC-G-E Industrial Ethernet Switch, we are able to get snmp information (ifOutOctets, ifInOctets, ifOperStatus) for port 1-8 Exemple : ifOperStatus on port 1 = 1.3.6.1.2.1.2.2.1.8.1 But when we try to get Combo Gigabytes port 9 and ...

Hi, We have an SG200-18 which randomly stops responding and the connected users does not have access to internet.  Among the 18 Ports, 16 Ports are configured for internet (internet VLAN) and 2 ports are configured for Video (Video VLAN). Now, when t...

Hopefully someone on here may have some insight on this.  I was given a SG200 26P switch.  I plug it in and the system light just blinks at me.  Now I know that this means it's using it's default IP address but none of the ports light up or will oper...

I am looking for a little help as I am fairly new to configuring switches. I have two 2960X switches in a stack and have the following questions. 1. How can I force one of the switches to always be the stack master? 2. What is the proper method to c...

hello i have cisco 2960 switches and i want to configure SSH so that i can access them from the command line. do you have a simple configuration ? (i will set my own password, not the example one ) can you help ?

Hi all, Our network comprises of the N7k & N5k, how do we find out the concurrent and limit connections using show commands ? Thank you for all help. Duc Vu

I successfully replaced my DGS-1100-24 switch with a 26 port Cisco SG200.  There is however one issue with the remaining; attached dlink switches that were configured to use a management vlan do no longer obtain a dhcp address. This was working fine ...

Hello, I have a configured cisco SF300 with access ports secured using 802.1X and with dynamic VLAN assigment (based on the response from the Radius server). Everything works just fine and now I'd like to give access to multicast video stream (IPTV) ...

I am very new switch configs.  I need to know what steps I have to take to enable the DHCP Server on a SF300 series switch????  I keep getting errors to disconnect all DHCP clients, but don't know how or where to go.