Switches - Small Business

Hi allWe've have a 2 SGE2010-48 port, stacked.4 LAGS are denifed, two on primary, whitch are working, two on slave unit are NOT working.Devices connected to LAGS are de the same and same configuration (Cisco ASA 5510).Any way to fix this?

DHCP I have a cisco 2921 router connected to a cisco sg300-52 L3  switch. The switch is configured with several subnets and I need to use  the router for DHCP. I setup DHCP on the router to assign addresses to a  subnet on the switch but cannot get i...

Hello all,I have a very strange situation regarding 2 SRW248G4 switches (1.2.2a firmware).Trying to collect statistics for these switches, I noticed that ifHCOutCounters increases than decreases (!!!), querying about at 5-10 seconds interval. For exa...

I am running a small home network and purchased an SD2005 switch so I could run gigabit and get top speed from my attached NAS server.Recently I have noticed a problem with the SD2005.  Occasionally (about once a day), it will just start rapidly beep...

hello everyone,    I have SGE2010 switches and I want to implement Multiple VLAN's. Im a newbie and starting to study VLANS'sI want to implement 5 VLAN's on my test lab network and here as follows:192.168.1.x default192.168.2.x192.168.3.x192.168.20.x...

Hi,I have a Campus LAN setup which is layed out using Cisco SRW2024 and SGE2000 SB switches. On the LAN we are running various services. These are CCTV, VOIP(SIP), Public Address(multicasting) and Internet hotspots to various locations. I have attach...

Hi,I've recently taken over a network which has got 4 Linksys switches - 3 * SRW2048 and 1 * SRW2024One of the SRW2048 devices has 2 LAGs setup (of 4 ports each) connecting to the other 2 SRW2048s (both with a single LAG). So far, so good.However, be...

Hello people,My name is Mike. Its the first time Im using the Cisco Support Community.Im looking for the MTBF numbers of 3 Cisco products.Sometimes they are provided in the datasheet, but for these products I couldnt find them.Ive contacted the Cisco...

Does the Linksys SE2800 gigabit 8 port switch support jumbo frames?  Anyone have this switch?  Any issues?  Looking to replace a netgear gigabit switch that likes to forget that it has gigabit machines connected to it.

Hi, I have a SLM248G4S but do not have the IP, Username or password, Is there a way i can get on the unit or do a master reset without logging in to the gui? Any help would be great.RegardsJamie

Afternoon, folks...     We just switch over to two SGE2010 switches from old Cajun routers. Many things worked out just fine... but as always, there were some issues.We run 4 VLAN's on this network as follows:10.20.1.x default10.20.20.x 10.20.30.x10....

Hi,I noticed that the SG300 series of switches do not support CDP.  However, will these switches pass CDP packets onto an upstream device?Thanks

HiPer this discussion;https://supportforums.cisco.com/message/3350444#3350444I would like to get a copy of that beta 1.1 OS for the SF 300 series.  Is that possible?  If so, can a Cisco support person please contact me via mail or call me?  See my pr...