Switches - Small Business

We have a SFE2000 switch and we're having trouble configuring IGMP snooping.  It is enabled but we are still seeing multicast traffic on ports which have definitely not done an IGMP join - indicating something is not right.  The literature on the swi...

Hi,We have bought 1 of SLM2048 for our office to upgrade two old switches to one 1GB network. I wonder what is the reason that eveery now and then the trafic slows down to about 10 to 20 kB/s and I need to reboot the switch to get it working again. i...

I have a question about my Cisco Small Business Switch SRW2008.I know that this Switch should work with VRRP.But now my question: works this Switch with the specific Cisco Protocols GRBP or HRRP too?Thanks for your Answers.

Hello,I’m trying to configure a Linksys  SRW208P with VLAN and QoS to prioritize VoIP traffic.  I need a little  (a lot, really) of help with the strategy and setup.  The  elements:To the SRW208P switch we will connect 4x Cisco 7940G phones  and the ...

I have an SRW2008 switch, and it appears to be adding an extra byte at the end of some packets.  The value of the byte is always 0x0F.  Can someone tell me why this might happen, and how can I configure the switch to stop doing this?

i would be very happy if you could help me rectify this problem.my problem is when connect if goes on and off and sometimes am not able to connect even....i only see the login and password fields and when i log in i only seethe lego of cisco /linksys...

While I'm familiar with the Catalyst line of switches, I have not worked on the ESW models.  I'm looking for anyone that has done this successfully.  Can the native vlan be changed on both sides, is it possible to limit the vlans allowed across the t...

Can you pls let us know wheather in SGE2000 Multicast forwarding is possible if yes pls. let me know the procedure for the same,

Model: SGE2010PFW: 3.0.0.18In the web GUI:Under DHCP Snooping ---> VLAN SettingsIt does not allow you to enter a VLAN higher than 4092I configured it to listen on VLAN 4094 via the CLI just fine.I believe this should be fixed in the web GUI.

I bought a Linksys SRW224G4 3 days ago and yesterday i had the time to made some configuration.Today, i plugged in the power cord and wondered why all LEDs were on.The Switch wasn't reachable over the network,  so plugged in the Serial-Cable and saw ...

Dear All,What is max power consumption of SRW2008, SRW2008P, SRW2008MP switch?There is nothing about it in the DS or UG.Best Regards,Lukasz

I have a core 6509 set up with the management VLAN as VLAN 2 with an IP address of 172.19.1.1/24.  I set up a Linksys SRW2048 also using VLAN 2 as the management VLAn using 172.19.1.201/24.  I am able to trunk all my VLANS but can't access or ping fr...