Good Afternoon All-We are working on a new networking project, the client has very limited funding resources. REQUIREMENTS:Separate VLANS for VOICE | DATA | SECURITY SYSTEMS | WIRELESS.But, Need to Maintain Connections to Domain Resources for DNS and...
Whilst carrying out resilience testing to confirm igp/ebgp multipath is working, I have stumbled upon the below issue.The attached sketch crudely shows the topolgy of the network. 2 cores with a cross connect running ibgp, from each of the cores I ha...
I got a catalyst 4948 10G switch that does routing and the whole bite. Well first it was stuck in a boot loop it took me a while but I got it out. Then when I was configuring the switch I screwed up an IP so I figured I would just start over.Of cours...
Customers are reporting poor Skype screen sharing over. These users communicate over a GRE tunnel configured on a Cisco switch from this branch office to a remote data center. I believe that Skype is hosted in cloud. How would we go about classify...
Greeetings to all, I am continuously getting log on my 3560 switch of %SW_MATM-4-MACFLAP_NOTIF: Host 0090.e800.0081 in vlan 12 is flapping between port Gi0/9 and port Gi0/8. I have connected cisco 3560 to two moxa switches on these ports 0/8 and 0/...
Hello, I have a Cisco Nexus Switch and trying to configure NAT for AWS Direct Connect Public Virtual Interface. Switch : Nexus C9504 Version : 7.0(3)I4(7) It appears that NAT is not supported on 9500s. Can someone please confirm ? What are the opti...
So I'm brand new to Cisco awesome equipment though. I bought a switch and when I first booted it up it was stuck in a boot-loop. So I researched and read and through trial and error I got it unstuck and the correct image in place. So I am configuring...
While learning to register the network-essential license and figured I didn't need the DNA-essential license, I deleted the DNA essential technology package. I didn't realize there was no need to delete the DNA essential technology package and in fa...
We have been having this issue for quite some time now, and I finally have time to actually pose the question here as I cannot come up with anything searching. On all of our 3750x's and some (if not all) of our 3650's, we have some port types that ha...
I am looking for an European adapter for my 10 port SG300 POE. Anyone who can tell me how to get one? I lost mine. many thanks in advance
Hi Dear Friend I have switch 3850 with Trunk portNo i want Limit VLAN BW Per vlan note: Switch is Layer 2 OnlyI want pilocy any trafiic TX OR RX on vlan 34 For exampleVLAN 34 Shapping 60M TX and 60M RX THX
Hi everyone, Some switches which don't use POE have large PSUs by default. Such as the new 9300-24S which is 24 SFP's and no POE support,but defaults to 715W PSU. https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9300-series-switche...
Hello everyone, I am trying to configure L2 NAT on a Cisco IE2000 and I am having a connectivity related issue. The IE2000 has trunk link to my private LAN (172.16.173.0/24) and an Access link to my PLC LAN. And I am trying to NAT between 172.16.173....
Hey, so I have been trying to figure out how to configure Radius over TLS on the CAT9300 device and get a Wire shark capture showing that it is working. On my device I have configured it just like the Cisco Website says to configure it:Device(config-...
Is the two commands "errdisable recovery cause psecure-violation" and "errdisable recovery interval 120" used in the configuration of CISCO ISE in CISCO edge switches.
