Switching

Hi Guys, I have a cisco catalyst 3950 g that has the defualt config with only 1 vlan. We have give the switch IP address 192.168.130.16 All of the servers connected to the switch are in the range 192.168.130.0/24 we can ping the servers are connecte...

Hi, I have this problem on two members of a Cisco 3850 stack (8 members) : today, beetween 11h25 and 11h35 and beetween 12h45 and 13h00, only on two members of the stack, all the PC on a specific vlan lost the connection (no ping to their IP). The ot...

HI all    I need  sample configuration for device management local username and password with Sha256 algorithms   I have few information about device with below    version: NX-OS 7.0(3)I7(4) Device: cisco Nexus 3048 Current password and username CLI ...

In the case of L2 trunk port-channel on which LACP is configured to be active, where one side is a Nexus switch and the other side is a compute host, is there any configuration case in which VLANs on the Nexus switch and the compute host need to be t...

Dear Team,   We are facing issue while doing wifi unification eg:   We have AD trust with our Dubai office & india office we have added there end controller IP , as well as radius IP in our radius server with same key including NPS policy, wifi polic...

Hello,   My clients WS-C2960X-48FPS-L are running LAN-Base license. Do the switches support intervlan routing?   Sample config:    ip routing  interface vlan 100  ip address 192.168.100.1 255.255.255.0   interface vlan 200 ip address 192.168.200.1 25...

Hello Experts I have core firewalls (two units) active/standby in transparent mode. Both firewalls are connected to two core Nexus 7k (in vpc) one-leg (off-path) in such as way that:   There is one port-channel say Po1 on Nexus with active firewall a...

We have recently upgraded Cisco 3650 stack switch from 03.06.05E to 03.06.08.E. The switch was on install mode but we upgraded it using bundle mode. The switch was upgraded successfully but the member switch went into provisioned state.  We had to co...

Hello all please short description of this service service-policy input XXXX     thanks

Dear Team,   I am new to cisco ASA i need to allow port 80 from LAN IP 10.0.0.0/8 towards source 11.0.0.0/8 how can allow the port source & destination IP.   Also i am able to ping multiple IP from firewall inside interface to outside towards other e...

Hello, First time poster, I know a lot of people ask this question about what to get and so on and so forth, But currently I have a new job and am looking to get to a CCNP for routing and switching, in the path of CCENT >CCNA > CCNP.  I have at home ...