Hi All, When I try and apply any of the policy-maps outbound on a Vlan interface it accepts the command but does not apply the configuartion. Has anyone experienced this and does anyone know why it doesnt apply? The config is below. All three Poli...
Forum Posts
Resolved! LCAP Etherchannel Throughput
Good morning guys, A very quick question. If I have an LCAP etherchannel consisting of 2 physical 1Gb/s interfaces. Does the channel get aggregated to 2Gb/s throughput? My understanding was that whilst theoretical throughput would be 2Gb/s, actu...
Hi, newbie here. I'm trying to test/debug a custom router, now I'm working on multicast, but not sure if it's my misunderstanding or router bug(I won't surprise if it is from previous experience). The topology is fairly simple: one router. PC A ...
We had an IPT conversion last Friday, and a 3560-48 PoE switch just would not deliver any power. Tried a reload, shut/no-shut the ports, and no power inline/power inline auto on all ports configurations. I wonder if there is some kind of internal fus...
Can we add DNA Advantage to any switch (2960's, 4500's) for existing clients? Or there exceptions?
I'm trying to trace the connection between Main SW and Distribution SWfrom main SW , i follow the sh cdp neig detailbut when i ssh to the IP of the neighbor SW, it seem like it going to different SWHow is it possible ?
Hello, I recently got a new ASR1001-X running Cisco IOS XE Software, Version 16.04.01.After trying now 4 days without success creating a simple bridge between 2 ethernet interfaces I decided asking here. All documentation that I found stated somethin...
Hello, I think I found a bug although I am not sure, so please help. I have 2 cisco with the image c1841-adventerprisek9-mz.123-14.t5.bin those 2 have VPN in between them...for some reason, they are restarting at the same time. I am thinking it is ...
I been instruct to register our devices to new destination of Tacacs ISE server, but when tested, i not able to communicate with the ISE server, why is it ? below is the config
Hi,One of my clients uses the macro function on their Catalyst 2960 access switches.This macro is of this type:macro auto execute XXX {conf$ INTERFACE interfaceswitchport access vlan 508switchport voice vlan 210no service-policy input QOS-BA-Userserv...
Resolved! DMZ switch standard configuration
Hi Team, I'm currently working on creating a standard configuration for switches connecting the firewalls (DMZ Switch). Can you please suggest what would be considered as the most important commands that can be used in this scenario? Apart from the u...
Hi all, I've implemented a back to back vPC on a data center network by using 4 Nexus 9372X distributed in two different sites. Each couple of distributed Nexus corresponds to a vPC domain and auto recovery feature has been configured on it. 2 Nexus ...
I am getting an error on my Cisco 2960G switch that says “ duplicate address 192.168.1.10 on Vlan1, sourced by 08cc.68bc.1304.” The switch is connected to a Cisco 1800 router. This is a test network that I am using to study for my Cisco certifica...
Resolved! 3850 POE fault in all ports
I have just configured a new 3850 switch, WS-C3850-24T-S. All the functions on ports works fine except POE, no one port is providing it. #sh env all --- on two power sources (350 and 715) shows ok on power and POE #sh power inline is not showing anyt...
All, I am using iperf to test throughput for server on different network going through my ASA. Throughput is very low but when I test server to server on the same network its fast. If I preform a iperf test to server to server on different ...
