Hi, I am in the process of buying some switches. I am comparing both 3650 and 3850 and I found the 2 below comparisons: WIRELESS ACCESS POINTS per switching entity (Switch or Stack) 25 vs 50 WIRELESS CLIENTS per switching entity (Switch or Sta...
Forum Posts
Hi, Can someone give me a quick review of what is EIGRP stub, OSPF for routed access and EIGRP stub routing? How do they differ from the EIGRP and OSPF in the IP Service switches? Thanks
I just want to config ASA 5518 with several VLANs using one Interface, now I got SG200 smart switch but can't connect with vlan that I created, did any one know now to fix it?
I can't seem to find any documentation for most of the service commands in relation to routers. So does anyone know the function of "service disable-ip-fast-frag" command and what it does exactly? Regards.
Hi, I need help with configuring Qos on 3850 switch,the problem is that the 3850 switch have a WAN link connected with GRE connection to another router.Now from my understanding, 3850 does not support Qos over GRE tunnel,is there a solution for this ...
im handling a big network , with switches , core switches , wlc , cucm and an old firewall "PIX" , im trying to do as much preparation as possible before anything happen , so far what i have done is : -take run config , show mac address table , show...
Hi Team, Resource LAN Lite (default) LAN Base (default) Unicast MAC addresses 16,000 16,000 Does this mean that switch support upto 16k mac addresses it self ?
Hello All, I had a deffered IOS on my stack, so i have installed the new IOS and issued a reboot and the switch stack came back up.... however, the switch which was active is no more active as the highest MAC address is now active.. i wanna mak...
Hi,Whether I can Use Mgmt 1 interface on Nexus 5000. I can see two interfaces on the panel but not getting the option. I was once updated that this will be enabled at "later stage"thanks in advance.....With regardsPrasad. K
We had a local user setup on our pair of 6807s operating in VSS that we had been using for a while. I was asked to setup radius authentication for domain users. So I setup AAA first as it is on all our other switches on the network and then setup r...
Problem in Etherchannel Configuration using Ports of different M3 Linecards I use two Nexus 7706 with NX-OS 8.2(1); each Device has two Linecards N77-M348XP-23L Slot 2 N77-M324FQ-25L Slot 5 I want to create a Portchannel between the two devic...
Hi All I was looking for a command that would count how many calls match a dial peer, so I found the "sho dial-peer voice busy-trigger-counter", but my questions is how old those calls are? the results that I see are calls per day? per month? per...
I have updated to the following versions and when I go to the Access Control Policy editor, the screen goes to the default policy instead of stopping and allowing me to add/create a new Access Control policy. Cisco Adaptive Security Appliance Softw...
Hi I am trying to figure out how to configure Layer 3 port-channel with subinterfaces. This is my topology. Two physical interfaces will be bundled into a single port-channel. My CSR will act as a "Router On A Stick". All interfaces on the switc...
1.Download from AZURE CISCO CSR on East US location to local ubuntu box. root@kernels:~# curl -O http://username:password@52.168.161.119/bootflash/test10M.pdf% Total % Received % Xferd Average Speed Time Time Time CurrentDload Upload Total Spent Le...
